Tabla de contenido
ES
PRECAUCIONES
Esta unidad puede producir campos electromagnéticos debido al altavoz, por favor coloque la unidad alejada de
PCs o TV unos 60mcm, si no el campo magnético podría afectar a la imagen y sonido de estas unidades.
Después de utilizar la unidad, desconecte el cable de la toma mural.
Para la batería recargable incorporada:
1. Debería ser cargada más de 8 horas antes de usarla, asegúrese que está alimentada todo el tiempo.
2. Debe ser cargada al menos 8 horas después de su uso para proteger la batería y el alimentador.
Por favor, sustituya la batería incorporada por otra del mismo modelo (12 V /7 AH) si ésta se daña, si no podrá
dañarse la unidad, maneje la batería dañada adecuadamente para evitar contaminar el medio ambiente.
Por favor, no use la unidad si ocurren estas circunstancias, diríjase sólo a un técnico especializado:
1. Cable de red o alimentación dañados.
2. La unidad se ha mojado por la lluvia o han caído objetos en su interior.
3. Algunos componentes se han dañado.
No desmantele el producto. El mantenimiento e inspección debe ser llevado a cabo por personal cualificado para
evitar el riesgo de descargas eléctricas.
Asegúrese de apagar la alimentación después de su uso, si no la batería se descargaría y podría dañarse,
acortando la vida útil de la batería.
Después de usar un emisor inalámbrico, retire la pila para evitar su descarga y que pueda dañar el emisor.
CONTENIDO
Cable de alimentación.
Emisor de petaca
WAP-650
Amplificador PA
Micro de cabeza
y receptor
Si el embalaje se encuentra dañado, notifíquelo de inmediato a la agencia de transporte. Conserve la caja como
evidencia ante la inspección de la compañía de trasporte. Por favor, contacte con su distribuidor para información
adicional.
Micro inalámbrico
de mano
Micrófono Lavalier
Página 10
Manual de Instrucciones
OPERATION WITH AUX INPUT
There are 3 AUX inputs.
volume knob can be controlled.
OPERATION WITH AUX OUTPUT
AUX Output could be connected to a recording system. You can record while using the amplifier system.
HOW TO CHARGE THE BUILT-IN 7AH BATTERY
1. It is recommended to charge the battery for the first time use for 12 hours.
2. Turn the main switch to "OFF/Charge" and the battery will be charged wit a consistent current and voltage.
3. The charging indicator will change from bright to dim with the battery charging, the LED will off when the
battery is fully charged. When the battery is getting low, you will hear a buzz reminder from the system,
asking you to charge the battery immediately. Recharge the battery over 8 hours before you are going to
use it. When it is full charged over 8 hours, it can operate for more than 10 hours.
HOW TO REPLACE THE BUILT-IN 7AH BATTERY
1. After the 7AH rechargeable battery is full charged the main unit will operate with several hours running down
the charge. If this operating time is been reduced in time and the battery draining very quicky, that means the
battery must be replaced.
2. Open the battery chamber door, then take out the old battery and put a new inside. Connect its wire
correctly and settle the battery. Put the battery chamber door and charge the new battery over 8 hours.
NOTES: The + - polarity of the built-in 7 AH battery must in correct direction or it can not work.
Handle the damaged battery appropriate to avoid pollue the environment.
HOW TO CHARGE THE 8.4V RECHARGEABLE BATTERY
1. Put the 8.4V rechargeable battery into the charging chamber in correct polarity.
2. The 8.4 V rechargeable battery can be charged in the below two situations:
a) In AC power, it can be charged in the ON or OFF situation of the main unit.
b) In DC power, but the unit is ON, which is supplied by the built-in 7 AH rechargeable battery or external
12 V DC, it can be charged.
3. The charging LED lights while it is charging. The charged time should be over 8 hours.
4. NOTES:
a) Do not put the unrechargeable 9V battery inside the charger for charging, it can explode.
b) Make sure the polarity is correct or it may damage the battery.
c) The charger chamber has the limited position assembly for correct put in battery. If you can not easily put
in the battery, do no force into the chamber, be carefully and check the correct polarity and position, then
install the battery again.
TROUBLESHOOTING
If you have any problem with the system, please check the main power and batteries for microphone sets and
rechargeable built-in battery. If you are using a new 9 V battery, make sure you have put it in a correct position.
Screaming from the speaker.
1. Adjust the speaker volumen to the minimum.
2. Adjust the transmitter volume control to a low level.
3. Change the speaker direction to avoid direct feedback.
4. Turn the tone controls to the lowest level.
Noise or abrupt stop
1. Built-in battery low, please use AC power instead to power the system.
2. Check the cable connection to the speaker. The cable might be broken.
3. Possible frequency interference with another transmission. Contact with your dealer in order to change channels
for better reception.
WAP 650
You can connect a CD, external MP3 into this jack to play external audio sources. Its
Page 7
EN
User Manual
WAP 650
Tabla de contenido
