Jonsered GC 2225 Manual De Instrucciones página 17

WARNING! When the engine is started
!
with the choke in either the choke or
start throttle positions the cutting
attachment will start to rotate
immediately.
Hold the body of the machine on the ground using your
left hand (CAUTION! Not with your foot!).
Firmly grasp throttle lockout (A) and throttle control (B)
with left hand, pull the starter knob quickly until engine
attempts to start, or maximum 5 pulls.
B
Never twist the starter cord around your hand.
After engine attempts to start, or maximum 5 pulls, move
the choke lever down to run position.
Grasp the throttle lockout (A) and the throttle trigger (B)
and repeat pulling the cord until the engine starts. Make
sure that the machine reaches full throttle and then release the throttle trigger. Once the engine starts, allow
the engine to warm up for 30 seconds before applying full
throttle.
CAUTION! Do not pull the starter cord all the way out and
do not let go of the starter handle when the cord is fully
extended. This can damage the machine.
CAUTION! Do not put any part of your body in marked
area. Contact can result in burns to the skin, or electrical
shock if the spark plug cap has been damaged. Always
use gloves. Do not use a machine with damaged spark
plug cap.
STARTING AND STOPPING
A
Stopping
Stop the engine by switching off the ignition.
CAUTION! The stop switch automatically returns to the
start position. In order to prevent unintentional starting,
the spark plug cap must be removed from the spark plug
when assembling, checking and/or performing
maintenance.
–
English 17