Disposal And Recycling; Replacing The Power Cable; Cleaning, Maintenance And Ordering Of Spare Parts - Neptun Premium NPTP-E 5000 Manual De Instrucciones

Anleitung_NPTP_E_5000_SPK7__ 08.06.15 08:07 Seite 10
GB
6. Operation
You can put the equipment into operation after you
have thoroughly read the installation and operating
instructions. Pay attention to the following points:
Note!
The switchbox (Figure 2/Item 5) may only be installed
outside the well.
1. Lower the pump into the well or shaft using the
securing cable.
2. Ensure that the pump is completely submersed in
the water.
3. Connect the mains plug on the switchbox to the
socket.
4. The mains indicator (Figure 2/Item 7) will be lit.
5. Press the On/Off switch (Figure 2/Item 8) to start
the pump. The operating indicator (6) will be lit.
Note!
If the pump suffers an overload, the overload switch
(Figure 2/Item 9) will trip.
Push the switch in again after you have allowed the
unit to cool.

7. Replacing the power cable

The power cable of this equipment cannot be
replaced. If the power cable is damaged, the
equipment must be scrapped.
8. Cleaning, maintenance and ordering
of spare parts
Important!
Unplug the power plug prior to any maintenance
n
work.
For mobile applications, the equipment should be
n
cleaned with clear water after every usage.
Undo the fastening screws on the dirt screen
n
(Figure 1/Item 4) and clean the dirt screen and
intake section.
Insert the dirt screen again.
n
8.1 Cleaning the paddle wheel
If a lot of deposits collect in the housing, the bottom
part of the equipment must be dismantled as follows:
1. Disconnect the intake cage from the housing.
2. Clean the paddle wheel with clear water.
Important! Do not put down or rest the
equipment on the paddle wheel!
3. Assemble in reverse order.
10
8.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
8.3 Ordering spare parts
Please provide the following information on all orders
for spare parts:
Model/type of the equipment
n
Article number of the equipment
n
ID number of the equipment
n
Spare part number of the required spare part
n
For our latest prices and information please go to
www.isc-gmbh.info

9. Disposal and recycling

The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The
equipment and its accessories are made of various
types of material, such as metal and plastic. Defective
components must be disposed of as special waste.
Ask your dealer or your local council.