Legal Information - Ottobock 12S4 Instrucciones De Uso

6) Once the laminate has cured, drill the required fixing holes between the
outer socket and inner socket. Then remove the inner socket and the
shaped foam part. Next, drill the bore holes through the outer socket
and cap.
7) In the area of the joint connection, remove the lamination ring or shoulder
support from the laminate (Fig. 15). Create the outer shape of the outer
socket and cap by cutting and grinding (Fig. 16).
Subsequently, assemble the outer socket, cap and shoulder joint.
4.3 Adjustments and final assembly
12S4
The T-screw (Fig. 3; item 1) is used to adjust the friction of anteversion
and retroversion movement. Adjust it on the inner side of the outer socket.
2S7
Change the movement friction setting by adjusting the clamp of the ball on
the 501Z2=M4x18 Cap Screw (Fig. 12; item 1).

5 Legal information

All legal conditions are subject to the respective national laws of the country
of use and may vary accordingly.
5.1 Liability
The manufacturer will only assume liability if the product is used in accor-
dance with the descriptions and instructions provided in this document.
The manufacturer will not assume liability for damage caused by disregard
of this document, particularly due to improper use or unauthorised modi-
fication of the product.
5.2 CE conformity
This product meets the requirements of the European Directive 93 / 42 / EEC
for medical devices. This product has been classified as a class I device
according to the classification criteria outlined in Annex IX of the directive.
The declaration of conformity was therefore created by the manufacturer
with sole responsibility according to Annex VII of the directive.
18 | Ottobock