Changing The Brake Pads; How To Use Your Kickway E1 - Wayscral KICKWAY E1 Manual De Uso

The part number of the brake pads mounted on your scooter is as
follows:
Model: Bolids
Part no.: M05
Remember that new brake pads must be run-in. Running in can be performed by riding for a few minutes
and operating the brakes, alternating between abrupt stops and light braking.

2. Changing the brake pads

Remove the wheel and remove the worn brake pads from the brake calliper. Position the new pads in the
calliper so that the braking surfaces are in contact. Do not touch the braking surfaces. Insert the brake
pads one after the other into the brake calliper.
Then, adjust the brakes as described in the previous paragraph.
C. How to use your KICKWAY E1
• Step 1: Check that the silicone cap covers the charging connector and that your product is not
damaged.
• Step 2: Unfold the scooter as recommended in section "III. Folding
EN
and unfolding the scooter" and press the "On/Off" button. Enter the
electronic lock code as described in section "II. Electronic locking
of the scooter".
• Step 3: Once the scooter is switched on, check that the stand
is folded up, put one foot on the board and start gaining forward
momentum by pushing on the ground with the other foot, without
using the throttle.
• Step 4: You must reach a speed of 3 to 5 km/h to be able to use
the throttle and switch to electric mode. To accelerate, use the
trigger or throttle lever near your right hand. Once in motion, you
can adjust the speed ratio using the "+" or "-" control button.
130