Connecting Audio; Date And Time Setting - Velleman IVSPROM2 Manual Del Usuario

Connecting audio

• The DVR supports four audio inputs. Connect the audio output of an audio source to an audio input of
the DVR. Make sure to connect the audio channel to the corresponding video channel. Connector type
is RCA.
• There is also an audio output connector. Connect an audio device e.g. a speaker to this connector when
desired. Connector type is RCA.
Note: the cameras shipped with the IVSPROM2 DO NOT support audio recording.
Connecting Local Area Network (LAN)
Connect the DVR to a local network by plugging a network cable into the LAN port at the back of the DVR.
Connector type is 8P8C (RJ45). Setup is done through the OSD.
5.3 DVR power on
1. This device should be operated only with the type of power source indicated on the manufacturer's label.
Connect the indicated AC power cord to the power adapter, and plug into an electrical outlet.
Note: Before the DVR is powered on, make sure that (1) the cameras are connected and powered on for
the detection of the camera video system to be correct, and (2) a monitor (either LCD or CRT monitor, not
incl.) is connected to the DVR for correct video output detection.
2. Switch on the DVR with the power switch on the back of the device. It will take about 30s for the DVR to
initialize.
Note: To ensure that your DVR works constantly and properly, it is recommended to use an UPS
(Uninterruptible Power Supply, not incl.), for continuous operation.
5.4

Date and time setting

Before operating your DVR, please set the date and time on your DVR FIRST.
Note: DO NOT change the date or time of your DVR after the recording function is activated. Otherwise, the
recorded data will be disordered and you will not be able to find the recorded file from backup by time search.
If users change the date or time accidentally when the recording function is activated, it is recommended to
clear all HDD data, and start recording again.
Note: when using the DVR for the first time, leave it powered on for at least 48 hours continuously after the
date & time is set correctly. To replace the internal battery, refer to APPENDIX 6 in the full user manual.
1. Right-click to enter the DVR password with the password keypad. The default administrator password
is 0000.
The status will be changed from
2. Right-click to show the main menu, and select QUICK START > TIME SETUP to set the date & time.
GENERAL
TIME SETUP
EXIT
5.5 Clear hard disk
It is recommended to clear all data in the hard disk when using this DVR for the first time to ensure the
recorded data are not mixed with other data previously saved in the same hard disk.
1. Right-click to show the main menu, and select SYSTEM > SYSTEM INFO > CLEAR HDD.
2. The DVR will reboot when HDD data are cleared. For details, refer to §5.3.2 in the full user manual.
V. 02 – 02/05/2012
IVSPROM2
(key lock) to (administrator).
QUICK START
DATE
TIME
7
2009 / NOV / 17
15 : 35 : 53
©Velleman nv