Tabla de contenido
Idiomas disponibles
Idiomas disponibles
2
1
7
10
For all your parts and secrvice
needs for the IMER Small 50
pump and accessories contact
IMERUSADIRECT.com @
844-463-7776 or go to our
website @
wwwimerusadirect.com
11. START-UP (see fig.6)
After positioning the machine, prepare a bucket with a
quantity of approx. 10l. of grout. Pour the grout into the
machine hopper, or, in the case of using colorant products,
directly in the machine pipelines before connection. In the
latter case, pour approx. 10l. of coloured product into the
hopper. Check the material hoses to ensure perfect
condition, that couplings are intact and the relative seals are
fitted, then connect them to the delivery manifold and spray
jet. Check that the cam levers ( A ) of the couplings have
been tightened correctly and that the seal (B) is fitted as
shown in fig. 6a.
Close the spray jet valve (ref. 15a), turn the main switch
(ref. 3) to 1(ON), switch on the optional compressor if used,
and turn the selector (ref. 7) clockwise to the start position.
The pushbuttons (+) flow rate (ref. 6) and (-) flow rate (ref.
5), control the flow rate as shown on the display (ref. 8) at
30. Open the spray jet air valve (or pneumatic control)(ref.
15d) or start the machine by means of the electric remote
control: the pump starts to rotate slowly. Depending on the
machine configuration, wait until the grout in the hopper
reaches the level of the mixer, or until the coloured product is
delivered from the jet. At this point shut down the machine by
means of the pneumatic or electric control, fill the hopper and
start work as required. Adjust the quantity of material
delivered from the jet as required, by means of pushbuttons
(+) and (-). When the electric remote control is connected,
the selector should be set to the start position. The machine
is controlled exclusively by means of the electric remote
control.
The machine is fitted with protection against power failure: if
this occurs, the main switch must be reset to restart the machine
(turn from 0 to 1).
To stop the machine in the event of an emergency, press the
red emergency button (ref. 2) To isolate the machine, all moving
parts are shut down and then turn the main switch to 0 and
remove the electric power plug from the socket (ref.11).
IMER INTERNATIONAL S.p.A.
8
5
6
3
4
9
12
11
15b
15c
IMER MORTAR MIXERS
13
15a
15d
( B )
The machine must never be started up or remain in operation if
there is no material in the hopper, to avoid premature wear of the
stator and screw.
- Never direct the jet towards yourself or others
23
15
( A )
FIG.6a
FIG.6b
14
Tabla de contenido
