TFA Dostmann MAXIM II Manual De Instrucciones página 27

HOW TO INSTALL AND REPLACE BATTERIES IN THE
THERMO-HYGRO-STATION
The thermo-hygro-station uses 3 x AA, IEC LR6, 1.5V batteries. To install
and replace the batteries, please follow the steps below:
Battery replacement

Replace the batteries when the battery symbol of the temperature
station appears near the indoor data display.

When the batteries of the transmitter are used up, the low battery
icon appears near the outdoor data display.
Note:
In the event of changing batteries in any of the units, all units need to be
reset by following the setting up procedures. This is due to a random
security code assigned by the transmitter at start-up. This code must be
received and stored by the thermo-hygro-station in the first 3 minutes of
power being supplied to the transmitter.
SETTING UP:
WHEN ONE TRANSMITTER IS USED
First, insert the batteries in the transmitter (see "How to install and
1.
replace batteries in the thermo-hygro outdoor transmitter"
above).
2. Within 2 minutes of powering up the transmitter, insert the batteries
in the thermo-hygro-station (see "How to install and replace
batteries in the thermo-hygro-station" above). Once the batteries
are in place, all segments of the LCD will light up briefly. Following
the indoor temperature/humidity and the time as 0:00 will be
displayed. If this information is not displayed on the LCD after 60
seconds, remove the batteries and wait for at least 60 seconds
1. Insert finger or other solid object in
the space at the top center of the
battery compartment and lift up to
remove the cover.
2. Insert batteries observing the correct
polarity (see marking).
3. Replace compartment cover.
26