Tabla de contenido
EN
2.3 TIE THE CUFF
1.
Remove all accessories (watch, bracelet,etc) from your wrist. If your
physician has diagnosed you with poor circulation in your wrist, use
the other one.
2.
Roll or push up your sleeve to expose the skin.
3.
Apply the cuff to your wrist with your palm facing up.
4.
Position the edge of the cuff about 1cm~1.5cm from wrist joints.
5.
Fasten the wrist cuff around your wrist, leaving no extra room between
the cuff and your skin. If the cuff is too loose, the measurement will not
be accurate.
6.
Sit comfortably with your tested wrist resting on a flat surface. Place your
elbow on a table so that the cuff is at the same level as your heart. Turn
your palm upwards. Sit upright in a chair, and take 5-6 deep breaths.
7.
Patients with Hypertension: The middle of the cuff should be at the level
of the right atrium of the heart; Before starting measurement, please sit
comfortably with legs uncrossed, feet flat on the floor, back and wrist
supported. Rest for 5 minutes before measuring.
Wait at least 3 minutes between measurements. This allows your blood circula-
tion to recover. Take the measurement in a silent room. The patient must relax as
much as possible and do not move and talk during the measurement procedure.
The cuff should maintain at the same level as the right
atrium of the heart. Do not cross your legs and keep
your feet on the ground. Keep your back against the
backrest of the chair. For a meaningful comparison,
try to measure under similar conditions. For example,
take daily measurements at approximately the same
time, on the same wrist, or as directed by a physician.
2.4 START THE MEASUREMENT
1.
When the monitor is off, press "START/STOP" button to turn
on the monitor, and it will finish the whole measurement (pic.
5.A) (pic. 5.B).
2.
Press "START/STOP" button to power off, otherwise it will turn
off within 1 minute (pic. 5.C) (pic. 5.D).
3. DATA MANAGEMENT
3.1 RECALL THE RECORDS
1.
When the monitor is off, press "MEM" button to show the
average value of the latest three measurement records.If the
records are less than 3 groups,it will display the latest record
instead (pic. 6. A).
2.
Press "MEM" button again, it will display the latest measu-
22
Tabla de contenido
