Moving Mode: Interval Of Location; Setting The Movement Detection Sensitivity - Num'axes CANIBEEP RADIO PRO Manual De Instrucciones

Moving mode: interval of location

When your collar is positioned on « moving » mode (only modes from 5 to 8), the interval
between 2 beep sounds can be adjusted so that you can locate your dog moving.
Use the screwdriver supplied with the CANIBEEP RADIO PRO in order to activate the pre-set
inside the receiver box (See diagram 6).
Interval location pre-set

Setting the movement detection sensitivity

When leaving the factory, the collar is set to an intermediate position (medium sensitivity). It is
up to you to adjust the sensitivity of your CANIBEEP RADIO PRO to your dog's behaviour and to
the results you want to obtain.
To change the movement detection sensitivity, you need to remove the lid of the collar in order
to get access to the sensitivity adjustment screw situated inside the collar (see diagram 7).
2 examples:
a) After pointing, you still want to hear CANIBEEP RADIO PRO while your dog is sliding towards
the prey: with the supplied screwdriver, turn the sensitivity screw counter-clockwise to the
minimum (minimum sensitivity). Collar is still beeping while the dog is moving.
b) You want to hear CANIBEEP RADIO PRO only when your dog is perfectly still: the collar
stops beeping at the slightest movement of the dog: with the supplied screwdriver turn the
sensitivity screw clockwise to the maximum (maximum sensitivity).
GB - 30
Pre-set positions
Diagram 6
Results
Beep every 5 seconds
Beep every 10 seconds
Beep every 15 seconds
Beep every 20 seconds