HQ-Power VDP150CC6 Manual Del Usuario página 6

12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
b. Master/Slave Mode
When using the master-slave mode, the master should be set to address code "P2". The slave must be set to 01.
You can only have one master in this mode; the slaves will follow the master program mode.
The master setting of the master-slave mode is the same as the auto mode. Refer to the table in "Stand-Alone
Mode" for the address code setting.
c. DMX512 Mode
The address can be selected by setting the DIP switches (binary system). See example below:
VDP150CC6_v2
12 Mag-DBl-Bl-Gr-Wh-Yell-Red (20 sec)
13 Mag-DBl-Bl-Gr-Wh-Yell-Red (10 sec)
14 Mag-DBl-Bl-Gr-Yell-Red (30 sec)
15 Mag-DBl-Bl-Gr-Yell-Red (20 sec)
16 Mag-DBl-Bl-Gr-Yell-Red (10 sec)
17
18
19
20
21
22
23
24
25
26
27
28
Set the DIP switches of the master device as follows. Choose an address from the
table above.
Set the DIP switches of the slave device as follows. The slave device will react to
the master program.
Mag-Bl-Yell (30 sec)
Mag-Bl-Yell (20 sec)
Mag-Bl-Yell (10 sec)
Mag-Bl-Wh-Yell (30 sec)
Mag-Bl-Wh-Yell (20 sec)
Mag-Bl-Wh-Yell (10 sec)
Mag-Yell-Red (30 sec)
Mag-Wh-Yell (30 sec)
Gr-Bl-Wh (30 sec)
Gr-Bl-Wh-Yell (30 sec)
Mag-DBl-Bl (30 sec)
Mag-DBl-Bl-Wh (30 sec)
6
0000001100
0000001101
0000001110
0000001111
0000010000
0000010001
0000010010
0000010011
0000010100
0000010101
0000010110
0000010111
0000011000
0000011001
0000011010
0000011011
0000011100
HQ POWER