Herth+Buss eBlow Instrucciones De Operación página 22

Operating Instruction
Notice:
An incorrectly wired wall socket will
cause malfunctions during the charging
process.
Remove the plug from the
wall socket.
Have the wall socket checked
by a qualified electrician.
The available charging current
is established by:
The rated current of the charging cable.
The maximum permitted sustained
charging current for your wall socket.
Warning:
Never set the charging current on the in-
cable module higher than the maximum
permissible sustained charging current
for your wall socket! There is a risk that
the wall socket may overheat.
In this case, the in-cable module will redu-
ce the charging current to 6A to protect the
wall socket from overheating.
www.herthundbuss.com
95960021 | -022 | -023
Set the charging current using the
„up/down" buttons on the module.
After two seconds, the set value will be
saved automatically. This process is signaled
by the charging current display flashing
twice.
Connect the charging connector with the
socket on the electric vehicle.
The process of communication with the vehic-
le begins via the CP contact. Using a PWM si-
gnal, the maximum charging current is trans-
mitted to the vehicle. The ground conductor
connection is checked at the same time. If
there is no ground conductor, or if there is a
fault with the installation, the car symbol will
light up red.
22