Klipsch IC-400-T Manual De Instrucciones página 8

INSTALLATION
5
The wiring compartment is intended as a termination point for the audio circuit.
Access to the compartment is gained by removing the terminal cover located
on the back of the speaker. (For the IC-500-T-SC, the terminal is located on the
side of the speaker) The terminal cover will accept the appropriate conduit/wire
adapter. Feed wires through conduit/wire adapter and connect to the input terminal
according to the desired operation mode. Be sure to observe proper polarity.
Replace the terminal cover and tighten the conduit/wire adapter to secure the wire.
FOR IC-500-T-SC ONLY
WHEN CONNECTING 70V OR 100V
DISTRIBUTED LINE SYSTEMS, TAKE CARE TO
ENSURE PROPER TERMINAL CONNECTION.
CONNECTION TO THE LOW IMPEDANCE
TERMINAL COULD RESULT IN SPEAKER
DAMAGE, AMPLIFIER DAMAGE, OR BOTH.