Hose Connections - AO Smith AOW-3000 Manual Del Proprietário

8 INSTALLATION GUIDE
STEP 6 - Connect tubing
1
Brass Tee to Manifold "INLET"
(1/4" white tubing)
Take the white tubing leading from the
brass tee and insert it into the Manifold
port labeled "INLET". Push the tubing
all the way in until it stops.
DO...
Insert tubing all the way (.95") to prevent leaking.
Wet end of tubing for an easy install into inlets and outlets.
Cut excess tubing to prevent crimping, kinks, loops or folds.
HOT COLD
NEED HELP? GIVE US A CALL 833.232.9711
2
Manifold to Faucet
(3/8" white tubing already attached to faucet)
Insert the 3/8" white tubing (from
STEP 3 - Install RO faucet) from the
faucet into the Manifold port labeled
"FAUCET".
Depth to insert tubing
Diagram is actual size.
DO NOT...
Cut tubing too short. Always double-check
measurements before cutting.
Bend, crimp or kink tubing.
Discard excess tubing.
3
Manifold to Tank
(3/8" white tubing already attached to Tank)
Take the 3/8" white tubing leading from
the storage Tank and insert it into the
Manifold port labeled "Tank". Push the
tubing all the way in until it stops.
4
Air Gap to RO Membrane
(1/4" red tubing from faucet)
1. Insert restrictor into the end of the red tubing.
2. Attach 1/4" red tubing to the 90° elbow until it stops.
3. Attach 1/4" 90° elbow to the membrane drain port.

Hose Connections

1/4" WHITE BRASS TEE TO MANIFOLD
1
3/8" WHITE MANIFOLD TO TANK
2
5
Faucet to Drain Connector
(3/8" red tubing from faucet)
Take the 3/8" red tubing from faucet
and insert it all the way into the drain
connector.
WARNING:
Faucet will leak
if restrictor is not
installed.
1/4" RED MEMBRANE TO FAUCET
3
3/8" RED FAUCET TO DRAIN CONNECTOR
4
NEED HELP? GIVE US A CALL 833.232.9711
9