Tabla de contenido
Idiomas disponibles
Idiomas disponibles
4
INSTALLATION GUIDE
STEP 2 - Install System Manifold
1
Select an easily accessible area under
sink to mount System Manifold. Allow
at least a 4-6" clearance to the floor
below filters to allow ample space for
filter changes.
To help gauge the right location for
your System Manifold, insert First and
Third Stage filter sumps into Manifold.
Insert sumps by aligning top connection
points and push up and to the right
until sumps are locked in.
2
Mark wall placement for mounting
screws using the built-in bracket on
back of Manifold. Ensure holes are
as level as possible.
3
Drill two pilot holes for mounting
brackets using 1/8" drill bit for the
System Manifold.
Note: Do not drill into anything
beyond the cabinet wall.
Note: Drilling holes into solid surfaces or surfaces made of stone should only
be performed by a qualified and certified installer.
NEED HELP? GIVE US A CALL 833.232.9711
4
Insert anchors and mounting screws into
the wall leaving approximately 3/8" of
each screw exposed.
5
Remove First and Third filter sumps from
Manifold by turning each sump to the
left and pulling down before hanging
Manifold on wall. Mount Manifold on
wall and screw in place.
Note: Avoid over-tightening.
STEP 3 - Install RO faucet
You will need a sink top hole 1 1/4" in diameter for the faucet. If drilling a new
hole, ensure faucet body will mount flat against surface and there is sufficient
tubing between faucet body and System Manifold.
1
Place the metal escutcheon
and black gasket on the faucet
base and feed the tubing and
faucet threads through the
countertop hole.
ESCUTCHEON
GASKET
2
Slide the metal washer
onto the faucet.
Thread the faucet
nut onto the faucet
threads. Tighten
by hand.
WASHER
FAUCET NUT
3
Measure the white 3/8" tubing from the
faucet to the manifold and cut to desired
length. Leftover tubing will connect
Manifold to Tank.
NEED HELP? GIVE US A CALL 833.232.9711
5
Tabla de contenido
