The operating temperature of a handle is
75° to 80°, when you notice that your handle
works at more than this temperature, suspend
its operation and dismantle it for inspection.
IMPORTANT: Avoid bending or forcing the
hose into sharp corners as the hose increases
friction against the spiral wall of the hose and
greatly reduces the life of your vibrator assem-
bly.
Never drag the drive unit by pulling on the
flexible shaft hose, drastically damages the
shaft, greatly reduces the life of your vibra-
tor and may cause an accident by turning the
power unit uncontrolled.
MAINTENANCE
WARNING: Running the engine with persis-
tent spark knock or pinging can cause engine
damage. Running the engine with persistent
spark knock or pinging is considered misuse,
and the Distributor's Limited Warranty does
not cover parts damaged by misuse.
STORAGE
If possible keep your vibrator horizontal in a
special rack; Otherwise roll up trying to protect
the coupling. It is not recommended to hang it
because the grease can enter the head in pro-
longed storage.
GENERAL CLEANING
CLEAN YOUR VIBRATOR DAILY
Remove the shaft. With a wet cloth, clean the
vibrator assembly by removing all concrete,
dust and dirt residues you may have.
E N G L I S H •
TROUBLESHOOTING
THE SYSTEM DOES NOT VIBRATE
Pendulum and track bathed in oil: Change
head retainer. Clean parts.
Water inside the head: Change tip and tube o-
rings.
(Electric motor). Incorrect rotation: Change the
polarity of the cables in the plug.
Broken harness or damaged harness termi-
nals: Replace harness.
Damaged or broken couplings (grinding
wheels): Replace parts.
Cople
of
vibrator
(Wheels): Replace parts.
Damaged pin or nipple: Inspect parts and re-
place if necessary.
TECHNICAL DATA
VIBRATIONS PER MINUTE
LENGTH VIBRATOR SHAFT
VIBRATOR SHAFT DIAMETER
COUPLING TYPE
POWER
AMPERAGE
VOLTAGE-FREQUENCY
WORK CYCLE
NO LOAD SPEED
WEIGHT
U se r' s m a nu a l
broken
or
damaged.
3 400
(4 - 10) m
38 mm
DYNAPAC®
1,5 HP (1 100 W)
15 A
127 V ~ 60 Hz
60-20 min
3 570 r/min
19,8 kg (43,7 lb)
13