Instructions Of Use; Maintenance And Cleaning; Environment Protection - Jata electro HA464 Instrucciones De Uso

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

• Ensure the plug has an adequate earth base.
• The kettle works with electricity only. Never use the jug on an electric or gas cooker, nor in a
microwave, do not use it when it has a fissure.
• Never connect without the water level being over the minimum level, and not going over the
maximum level of the water level indicator.
• If the kettle is too full, the water may splash when it boils.
• Do not use any other liquid or additive than water in the jug.
• VERY IMPORTANT:
- Never immerse the jug and the base in water or other liquids.
- Never open the lid when the water is boiling.
• Don't allow children play with the appliance. Keep the appliance out of the reach of children.
• The exterior parts of the jug get hot. Use the handle to manipulate.
• The kettle must only be used with the base provided.
• Disconnect from the mains before removing it from its base.
• Always use with the lid on. Otherwise, the automatic disconnection system, when the water boils,
will not work and the water will continue to boil until it evaporates completely.
• Before using the kettle for the first time, make it works only with water a couple of times to clean
out completely.
• This appliance has being designed for domestic use only.
• If the cable were to deteriorate it must be changed by an Authorised Service Centre.

INSTRUCTIONS OF USE

• Lift the jug (3) to remove it from the base (7).
• Open the lid (1) by sliding the opening knob (2) to the handle direction and pour water into the
jug.
• Bear in mind that the water level must be between the minimum (MIN) level and the maximum
(MAX) level shown on the level indicator (4).
• Close the lid (1) and press it to get fixed correctly.
• Place again the jug (3) on the base (7).
• Plug the appliance to the mains and press the on switch (5) to the I position.
• The indicator light (6) will light on and the water start heating.
• The time to heat the water will vary according to the amount of water.
• Once the water is hot the appliance will automatically disconnect, the indicator light (6) will go
off and the on switch (5) will go to the 0 position.

MAINTENANCE AND CLEANING

• Before you proceed to cleaning it, ensure the appliance is unplugged from the mains.
• The base (7) may be cleaned with a dry cloth same as the base of the jug.
• Clean the outside of the jug with a slightly dampened cloth.
• With the use you may get alkaline residues in the jug. To clean them use an aluminium-friendly
alkaline remover. You will find it in your local store.
• If the appliance switches off before the water boils, it probably needs to be decalcified.
• Do not use chemical or abrasive products, such as metallic scourers, which may deteriorate the
surfaces of the appliance.

ENVIRONMENT PROTECTION

• Dispose the appliance according to the local garbage regulations.
• Never throw it away to the rubbish. So you will help to the improvement of the
environment.
6
Tabla de contenido
loading

Tabla de contenido