Operation; Getting Started; Cable/Network Type And General Setup - AEMC Instruments Wire Mapper Pro CA7028 Manual De Instrucciones

4.1

Getting Started

The instrument is switched on and off using the green power button
found on the lower right side of the front panel.
When the unit is first switched on, it will display the opening screen giving
the software version and remaining battery capacity.
The wire type (TIA568, STP...) and the Vp (Velocity of Propogation) is also
displayed. To change these settings, see § 4.2 below.
4.2

Cable/Network Type and General Setup

To enter a menu for Cable and Network selection:
• Press down on the
Typical display:
The > (line selector) is moved by pressing the
appropriate line is selected, the
be pressed to increment or decrement through the alternative options for
the selected item.
Wire Mapper Pro Model CA7028
CHAPTER 4

OPERATION

AEMC Instruments
Wire Mapper Pro V2.12
TIA568 UTP Vp=75%
button, then press the
>
Type = TIA568 STP
Vp = 71%
Feet
Eng (USA)
Contrast
SERVICE / Vp
button.
MAP /
button. When the
MAP /
and
LENGTH / Vp
buttons may
9