A C C E S S O R I E S - Sunrise Medical JAY Fit Manual Del Usuario

E N G L I S H
A. SPINE-ALIGN POSITIONING COMPONENTS
Spine Align Positioning Components are designed to
provide intimately shaped support with-in an "off-the-shelf"
back. Depending on your market, Spine Align components
may be included with your back.
1. Spine Align Positioning Component installation
a. Have the user remove pressure from the Back by
leaning or sliding partially forward if possible.
b. Remove the top cover pocket and lift the cover forward
to reveal the inside of the JAY® Fit Back.
c. Place the positioning component(s) on the Velcro inside
of the shell and reattach the top cover pocket.
d. Have the user test the current Spine Align setup
for comfort and support and repeat steps a-c until
adjustment is complete.
e. Multiple configurations and combinations of Spine
Align components can be used. If additional Spine
Align shapes or sizes are required, please contact your
Sunrise Medical authorised dealer.
f. Mounting an optional head rest. Head rests can be
mounted to the JAY Fit Back, using the head rest
mounting plate and head rest mount.
g. Securing the foam and cover to the shell.
• To secure the back foam and cover on the JAY® Fit
System back, slide the top edge of the cover over
the top lip of the shell.
• Press the back in place against the shell.
• Pull the two button snaps under the bottom of the
shell and snap into the buttons.
NOTE: If you require further information on the JAY® Fit
Spine Align system, please review our animation at www.
sunrisemedical.com.
Jay Fit Back
Positioning Components
Large Lumbar
Small Lumbar
Wedge
Curved Shim
Flat Shim
Posterior/Lateral Pelvic
Lateral Shim
Large Bean Bag
Small Bean Bag
23

A C C E S S O R I E S

Rev.D