Remote Control - hilton TDX16 Manual Para El Usuario

TDX16 -
User's manual
4.5

Remote Control

The remote control allows you to interrogate or controlled through the TDX16 the alarm
system connected to it.
Is it possible to activate this mode both during an alarm call as described above is by
directly calling the mode dial from a mobile phone can send DTMF tones.
When the connection is active, on the display appear:
listening to the pre-recorded message: "Insert code" (only COMMANDS code) if entered
correctly you enable remote management, otherwise if it is broken after about 30 sec. the
call ends.
Entered the code, the display will appear:
You will hear the message:
"System enabled" (or "System disabled" depending on the state of incorporation of the
connected).
"Network OK" (or "Absence network").
"Press 5 for ambiental listening".
"Press 7 per enable" (or "Press 9 for disable" if the system is ON).
"Press 0 for STOP CICLI".
NOTE : To stop listening, you can type
With the command <0> stops the cycle of calls and closes the current phone call.
At the end of the call, the display show :
18
2 5 C o n n e s s o . . . .
I m p . I N S E R I T O
C o n n e s s o . . . .
2 5
G E S T I O N E R E M O T A
.
2 5 F i n e C h i a m .
I m p . I N S E R I T O
security