Tabla de contenido
Idiomas disponibles
Idiomas disponibles
security
4.4
Alarm Cycles
When an event of alarm, the cycle of calls. The display will show:
In case of Network Failure, event timer part 600 seconds (10 min) before it is carried out
the cycle of calls. In case of network recovery, call cycle does not run.
Once connected you show :
You listen: "alarm system and/or absence network (depending on the event) enter code" if
correctly inserted (only CODE commands) switch to next step "REMOTE MANAGEMENT"
which will be described below:
otherwise if it is incorrect after about 30 sec. the call ends.
The alarm cycle continues with the next number in the address book. In each cycle, the
mode dial makes 3 attempts to reach the user entered in the address book, and then ends
the cycle.
2 5
C h i a m a . . . . .
> > > 1 2 3 4 5 6 7 8 9 0
C o n n e s s o . . . .
2 5
> > > 1 2 3 4 5 6 7 8 9 0
C o n n e s s o . . . .
2 5
G E S T I O N E R E M O T A
Operation
17
Capítulos
Tabla de contenido
