Safety Instructions; Application In Accordance With Regulations - Reloop TURN5 Manual De Instrucciones

CAUTION! For your own safety, please read this operation manual carefully before initial operation! All persons involved in the installation,
setting-up, operation, maintenance and service of this device must be appropriately qualified and observe this operation manual in detail.
This product complies with the requirements of the applicable European and national regulations. Conformity has been proven. The respective
statements and documents are deposited at the manufacturer.
Before operating this equipment we ask you to carefully study and observe all instructions.
Please remove the Reloop TURN5 from its packaging. Check before initial operation to make sure that the device has not been visibly damaged
during transport. If you detect any damage to the power cable or casing, do not operate the device. Contact your specialised dealer.

SAFETY INSTRUCTIONS

CAUTION! Please exercise particular caution when handling AC 115/230 V, 60/50 Hz (AC 100 V, 50/60 Hz for Japan) power voltage. This vol-
tage rating may lead to a critical electrical shock! Any damage caused by the non-observance of this operation manual excludes any warranty
claims. The manufacturer is not liable for any damage to property or for personal injury caused by improper handling or non-observance of the
safety instructions.
• This device left the works in perfect condition. To maintain this condition and to ensure a risk-free operation the user must observe the safety
instructions and warnings contained in this operation manual.
• For reasons of safety and certification (CE) the unauthorised conversion and/or modification of the device is prohibited. Please note that in the
event of damage caused by manual modification to this device, any warranty claims are excluded.
• The inside of the device does not contain any parts which require maintenance, with the exception of wear parts that can be exchanged from the
outside. Qualified staff must carry out maintenance, otherwise warranty does not apply!
• Ensure that the power will only be supplied after the device has been fully set up. Always plug in the mains plug last. Ensure that the mains switch
is in the „OFF" position when connecting the device to power.
• Only use cables that comply with regulations. Observe that all jacks and bushes are tightened and correctly hooked up. Refer to your dealer, if
you have any questions.
• Ensure that when setting up the product, the mains cable is not squashed or damaged by sharp edges.
• Prevent the mains cable from coming into contact with other cables! Exercise great care when handling mains cables and connections. Never
touch these parts with wet hands!
• Connect the power cable exclusively to appropriate shock-proof outlets. The only supply point to be used is a supply outlet in accordance with
specifications of the public supply network.
• Disconnect the device from the supply outlet when not in use and before cleaning! Be sure to hold the mains plug by the body. Never pull the
mains cord! When not using the turntable for longer periods of time, close the dust guard.
• Position the device on a horizontal and stable low-flame base.
• Avoid any concussions or violent impact when installing or operating the device.
• When selecting the location of installation, make sure that the device is not exposed to excessive heat, humidity, and dust. Be sure that no cables
lie around openly. You will endanger your own safety and that of others!
• Do not rest any containers filled with liquid that could easily spill onto the device or in its immediate vicinity. If, however, fluids should access the
inside of the device, immediately disconnect the mains plug. Have the device checked by a qualified service technician before re-use. Damage
caused by fluids inside the device is excluded from warranty.
• Do not operate the device under extremely hot (in excess of 35° C) or extremely cold (below 5° C) conditions. Keep the device away from direct
exposure to the sun and heat sources such as radiators, ovens, etc. (even during transport in a closed vehicle). Always ensure a sufficient ven-
tilation.
• The device must not be operated after being taken from a cold environment into a warm environment. The condensation caused hereby may
destroy your device. Do not switch on or operate the device until it has reached ambient temperature!
• Controls and switches should never be treated with spray-on cleaning agents and lubricants. This device should only be cleaned with a damp
cloth. Never use solvents or cleaning fluids with a petroleum base for cleaning.
• When relocating, the device should be transported in its original packaging.
• When starting operation, the crossfaders and volume controls of your amplifier must be set to minimum level. Bring the loudspeaker switches
into the „OFF" position. Wait between 8 to 10 seconds before increasing the volume to avoid damage to loudspeakers and the diplexer.
• Devices supplied by voltage should not be left in the hands of children. Please exercise particular care when in the presence of children.
• At commercial facilities the regulations for the prevention of accidents as stipulated by the association of professional associations must be
observed.
• At schools, training facilities, hobby and self-help workshops the operation of the device must be monitored with responsibility by trained staff.
• Keep this operation manual in a safe place for later reference in the event of questions or problems.

APPLICATION IN ACCORDANCE WITH REGULATIONS

• This equipment is a professional turntable that plays conventional 12" and 7" records. The equipment is connected to a mixing console.
• This product is authorised for connection to AC 115/230 V, 60/50 Hz (AC 100 V, 50/60 Hz for Japan) and is designed exclusively for indoor
application.
• If the device is used for any other purposes than those described in the operation manual, damage can be caused to the product, leading to
the exclusion of warranty rights. Moreover, any other application that does not comply with the specified purpose harbours risks such as short
circuit, fire, electric shock, etc.
• The serial number determined by the manufacturer must never be removed to uphold the warranty rights.
MAINTENANCE
• Check the technical safety of the device regularly for damage to the mains line or casing, as well as for wear of wear parts such as rotary, sliding
switches and the pick-up.
• If it is to be assumed that a safe operation is no longer feasible, then the device must be disconnected and secured against accidental use. Always
disconnect the mains plug from the outlet!
• It must be assumed that a safe operation is no longer feasible, if the device bears visible defects, the device no longer functions, following longer
storage under unfavourable conditions or after major transport stress.
8