Reversing The Door - GE 405 Manual Del Propietário

About reversing the door.
Drying Rack–on some models
A handy drying rack may be used for drying
articles such as stuffed toys, pillows or
washable sweaters.
Hook the rack over the lint filter so the rack
extends into the dryer drum.

Reversing the Door

Tools needed:
Standard #2 Tape-tipped
Phillips screwdriver putty knife
Open the door and remove the filler plugs opposite the hinges. With the door
1
completely open, remove the bottom screw from each hinge on the dryer face. Insert
these screws about half way into the TOP holes, for each hinge, on the opposite side
(where you removed the filler plugs). Apply firm pressure to get the screw started in
untapped holes.
2 Loosen top screw from each hinge on the dryer face half way. With one hand holding
the top of the door and the other hand holding the bottom, remove the door from the
dryer by lifting it UP and OUT.
3 Rotate the door 180°. Insert it on the opposite side of the opening by moving the door
IN and DOWN until the top hinge and the bottom hinge are resting on the top screws
inserted in step 1.
Remove the remaining screws from the side of the opening from which the door was
4
removed. With these screws secure each hinge at the bottom. Tighten the two top
screws of each hinge. Reinsert the plastic plugs on the side from which the door was
removed.
NOTE:
The drying rack must be used with the
TIMED CYCLE.
Do not use this drying rack when there are
other clothes in the dryer.
Needle-nosed
pliers
9