Sharp SJ-BA05IMXJ2-EU Manual De Uso página 9

CHAPTER -3: USING YOUR FRIDGE FREEZER
Chiller shelf (In some models)
Keeping food in the chiller compartment instead of the freezer or refrigerator
compartment allows food retain freshness and flavour longer while preserving its
fresh appearance. If the chiller tray becomes dirty, remove it and wash with water.
(Water freezes at 0 °C, but foods containing salt or sugar require lowered
temperatures to freeze)
Normally people use the chiller compartment for raw fish, rice, etc...
Do not put foods you want to freeze or ice trays in order to make ice.
Removing the chiller shelf
• Pull the chiller shelf out toward you by sliding it on rails.
• Pull the chiller shelf up from the rail to remove.
After the chiller shelf has been removed, it can support a maximum 16 kg load.
Humidity Controller (In some models)
When the humidity controller is in the closed position, it allows fresh fruit and
vegetables to be stored for a longer time.
In the event the crisper is full, the fresh dial that is located in front of the crisper,
should be opened. By means of this, the air in the crisper and humidity rate will be
controlled and the shelf life will be extended.
If you see any condensation on the glass shelf, the humidity control should be
placed into the open positions.
Bottle holder (In some models)
In order to prevent the bottles to slip or fall over you can use the bottle holder. You can also prevent making noise that
will be done when you open or close the door.
Adapti-Lift Door Shelf (In some models)
Fig.1
Note: Before moving door shelf is loaded, you must hold the shelf by supporting the bottom. Otherwise, door shelf
could fall off the rails due to the weight. So damage may occur on the door shelf or rails.
Visual and text descriptions on the accessories section may vary according which model you have..
Six different height adjustments can be made to provide storage
areas that you need by Adapti-Lift.
To change the position of Adapti-Lift ;
Hold the bottom of the shelf and pull the buttons on the side of
the door shelf direction of arrow (Fig.1)
Position door shelf the height you need by moving up and down.
After you get the position that you want the door shelf, release
the buttons on the side of the door shelf (Fig.2) Before releasing
the door shelf, move up down and make sure the door shelf is
fixed
EN -8-
Fig.2