CICSA ZETA ZT 800x500 Manual De Instrucciones página 18

TMU English - User guide Dry-towel models ZT, ZX, PUKITA, TUBÓN, DIJON, CUADRO, KARNAK, VERONA and ELFIE
Programming the "Chrono" mode
a) Setting the current day of the week and time.
Enter into "Stand-by" mode and press the [-] button at least 3 seconds.
On the upper part of the display the message "Set" will be displayed.
To set the day and time press the [+] button until the bottom part of the display the message "TED" is displayed.
Press the [ ] button to enter the editing mode. The blinking arrow indicates the currently selected day: Pressing
the [+] / [-] buttons the desired day can then be set. Press again the [ ] button to confirm the selected day.
After that, the procedure for entering the time starts and the display shows the currently selected time.
"Hours": Use the [+] and [-] buttons to set the correct hour and confirm the selected value pressing the [ ]
button.
"Minutes": Same procedure as for the hours. Confirm the selected value by pressing the [ ] button. At the end
of the procedure, the thermostat returns into "Stand-by" mode.
At the end of the procedure, the thermostat returns into "Stand-by" mode.
b) Enter into "Stand-by" mode and press the [-] button at least 3 seconds.
On the upper part of the display the message "Set" will be displayed.
To set the day and time press the [+] button until the bottom part of the display the
message "Prog" is displayed. Press the [ ] button to enter the editing mode. Now a time sequence can be
defined for each day of the week.
18