Tabla de contenido
CIRCUMSTANCE
When control board is
connected the train starts
running with out giving ride
Doesn't stop
Train doesn't start
Upon pressing START works
wrong
There are no lights
Thermics of the train are
disconnected
There is no sound in control
board
GUIDE OF DIAGNOSE AND REPARATION
SYMPTOM
When START is pushed trains
runs but F3 stops
Ride time finished and train
doesn't stop
Train doesn't stop when STOP
is pushed
The train stops as same as
stops for timer or through the
STOP push button
Nothing occurs when START
is pushed
K1 doesn´t work when START
is pushed
K1 and K2 start when START
is pushed but train doesn't run
It works stumbles with noise
There are no lights when train
stops
Lights in one the coaches
doesn't light up
Thermic F4 or F6 are
disconnected
Thermic F11, F12 ,F15, F9 or
F10 are disconnected
F2 magnetothermic
desactivate
F3 magnetothermic
desactivates
TIMER-SOUND led in the
music box lights up
CAUSE
Wrong connection of wires
between command board and
railway
Timer faulty
Push button faulty or
connections disconnected
K4 connections wrong or
contactor faulty
START push button faulty or
disconnected
Timer faulty
Belt motor broken
Chain of transmission broken
K2 contactor faulty or wrong
connection
T3 timer faulty
Magnetothermic F2 not
activated
Wrong connection
railway-command board
Teeth of the pinions are wasted
Shaft of reshipment wasted
K3 lights counter faulty
T2 timer faulty
Thermic disconnected
There is a short-circuited in
the installation
Too much consumption of the
engine
Too much consumption in the
lights or short circuit in any
lampholder
Diodes faulty or railway
shortcircuite
Railway shortcircuited or
wrong connection through
command board and raylway
Potentiometer set to minimum
REPAIR
Change direction of polarity of
connections in railway
A technician must replace by
one as same characteristics
A technician must replace or
check installation
A technician must check
installation
Check button and connections
Replace
Replace
Replace
A technician must check or
replace
A technician must replace
A technician must check
A technician must check
Replace
Replace
A technician must replace
A technician must replace
Connect lights thermic
Check connections and bulbs
A technician must check
engines and mechanism
A technician must check
installation and lights
A technician must check
A technician must check
Set potentiometer to + position
Tabla de contenido
