Leifheit Dry&Clean Manual De Instrucciones página 46

NOTE: The powered-on device operates quietly in stand-by mode. The window cleaner ge-
nerates its full power once the rubber lip of the window cleaner is placed on the glass pane
or is lightly pressed. The battery charge lasts longer due to this automatic power control.
• After suction cleaning the window, power off the device by pressing the appliance switch.
2. Interrupting work
• Place the device on its base (see fi gure 2) and power it off while it is not in use.
NOTE: If the window vacuum is not used for 2 minutes while it is switched on (no contact
between rubber lip and a hard surface), the device will switch into sleep mode; the LED
will fl ash in green. The vacuum function will be activated automatically once the rubber lip
comes into contact with a window pane. To interrupt or stop work for a long period of time,
always use the main power switch to shut the device off.
3. Emptying the container during work
• I f the maximum fi ll level (marked „MAX" see fi gure 6) of the dirty water tank has been
reached, the tank
must be emptied. NOTE: If the maximum fi ll level is exceeded, small amounts of water may
leak out of the
ventilation slots if the device is tilted too far. In order to avoid this, empty the tank before the
maximum fi ll level is exceeded.
• To do this, power off the device, open the side closure on the dirty water tank and pour the
water into a container or drain (see fi gure 7) Then close the tank again.
4. Ending work / cleaning the device
• Power off the device. Unlock the tank via the release button and remove it (see fi gure 8)
NOTE: The device cannot be powered on when the tank is unlocked.
• Remove the bottom cap from the tank and empty it through the opening in the base (see
fi gure 9). Rinse the tank out with clean water (see fi gure 10).
• Do not put any hard objects, such as a washing-up brush, into the tank as this may cause
damage.
• R elease the suction nozzle (see fi gure 11) and clean both nozzle and rubber lip under
fl owing water.
• Leave the device to dry fully while in the open position. Charge the battery after the work is
complete.
• Lock the tank before the next use by pushing the tank cover until it connects with
the tank. Be careful to ensure that the tank cover is pushed into the correct position
(see fi gure 12).
• Push the tank onto the basic device from above until you hear the connection make an
audible click. Insert the tank into the housing at a slight angle. (see fi gure 13).
CAUTION: The basic unit contains electrical components.
Therefore, do not clean the basic unit under running water!
NOTES
1. Do not use the window cleaner on rough surfaces.
2. Clean the device with a damp cloth.
3. Never submerge the device in water.
4. If your product does not work properly under normal conditions,
please contact your dealer with your proof of purchase.
GB 46
Figure 12: Lock the tank cover

Figure 6
Figure 7:
Emptying
the tank the tank the tank
Figure 8
Figure 9
Figure 10:
Cleaning the tank

Figure 11:
Release suction
nozzle
Figure 13:
Attaching
the tank