Technical Data; Maintenance - Bavaria BEC 1835/1 Manual De Instrucciones

Anleitung_BEC_1835_1_SPK7__ 02.04.14 09:47 Seite 22
GB
Whenever possible, use the claw stop as a
leverage point.
Cutting wood which is under tension
Danger!
Special care is required when cutting wood which is
under tension. Wood which is under tension from
which it is released by cutting may in some cases
react completely unpredictably and uncontrollably. In
the worst case this could result in extremely severe or
even fatal injuries (Fig. 22-24).
This type of work must only be performed by persons
who have been specially trained.

7. Technical data

Mains voltage:
Power rating:
Cutter rail length:
Cutting length, max.:
Cutting speed at rated rpm:
Oil tank capacity:
Weight with cutter rail and chain:
Protection class:
Chain type:
Zhejiang Yat ALP-50-52S (Oregon 91PJ052X)
Bar type:
Zhejiang Yat AP14-53-507P (Oregon 140SDEA041)
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
L sound pressure level
pA
L sound power level
WA
K uncertainty
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 60745.
Handle under load
Vibration emission value a
K uncertainty = 1,5 m/s 2
22
220-240 V ~ 50 Hz
1800 W
360 mm
350 mm
13,5 m/s
100 ml
4,6 kg
II / ®
91,7 dB(A)
108 dB(A)
3 dB
= 5,944 m/s 2
h
The specified vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equipment
is used and may exceed the specified value in
exceptional circumstances.
The specified vibration value can be used to compare
the equipment with other electric power tools.
The specified vibration value can be used for initial
assessment of a harmful effect.
Keep the noise emissions and vibrations to a
minimum.
Only use appliances which are in perfect working
n
order.
Service and clean the appliance regularly.
n
Adapt your working style to suit the appliance.
n
Do not overload the appliance.
n
Have the appliance serviced whenever
n
necessary.
Switch the appliance off when it is not in use.
n
Wear protective gloves.
n
Caution!
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain residual
risks cannot be rules out. The following hazards
may arise in connection with the equipment's
construction and layout:
1. Lung damage if no suitable protective dust mask
is used.
2. Damage to hearing if no suitable ear protection is
used.
3. Health damage caused by hand-arm vibrations if
the equipment is used over a prolonged period or
is not properly guided and maintained.

8. Maintenance

8.1 Replacing the saw chain and cutter rail
The cutter rail needs to be replaced if
the guide groove of the cutter rail is worn;
the nose sprocket in the cutter rail is damaged or
worn.
Proceed as described in the section "Assembly of the
cutter rail and the saw chain".
8.2 Checking the automatic chain lubrication
You should check the operation of the automatic
chain lubrication system on a regular basis in order to
guard against overheating and the associated