Hewi 801.35.99340 Instrucciones De Montaje página 6

Montagehinweis | Mounting information | Consigne de montage | Montagetip
Indicazioni per il montaggio | Indicaciones de montaje | Wskazówki do montażu
Safety advice
∙ Use the HEWI product only in the way illustrated.
∙ Improper installation/use can cause accidents
and injuries.
∙ The installer must pass on the installation and
use instructions to the user and they must be kept
for the whole life of the product.
Mounting
∙ On acceptance the product must be checked for
damage; any defects must be reported immediately.
∙ The product must be stored in a dry place and free
from pressure. The wall on which the seat is to be
installed must be flat, firm and capable of taking
the load. Only use fixing materials approved by the
wall anchor manufacturer for the intended purpose.
In case of doubt, contact HEWI's sanitary products
customer service.
∙ Ensure that the wall is suitable for mounting the
product.
∙ Mounting only by persons familiar with mounting
of the product and appropriate qualifications for
their activity.
Utilisation
∙ The form of the upper curve makes it difficult to
fix ropes or cords at the top.
∙ Bottom fixing point should be installed on a height
of 85 cm maximum.
∙ Do not use the hinged seat for any purpose other
than that for which it is intended, e.g. do not use
it as gymnastics equipment or as a climbing aid
or step.
Maintenance
Maintenance of the shower and bath grab rail or of the
system as a whole should be performed on a 6-monthly
basis and should encompass the following key points:
1. Inspection of fixing
The shower and bath grab rail should be mounted
firmly at all fixing points and should fit tightly to the
surface to which it is fixed. If necessary, the rose
caps should be removed and the screws used to fix
the rail in place tightened up. Any defects identified
during inspection should only be remedied by per-
sons qualified to do so.
2. Inspection of surface finish of grab rail.
The surface finish of the rail should have no fractures
6 | HEWI
or other damage that could cause personal injury.
There should be no gaps at the joints between the
straight elements and the bend elements.
Care and cleaning instructions
HEWI products are easy care and easy to clean.
Frequently, occasional wiping with a damp cloth
is sufficient. If using cleaning products the following
should be noted:
∙ Only use cleaning products with a pH value
between 6 and 8.
∙ Cleaning products that contain detergents such
as phosphates, soaps and tensides (surfactants)
as their active substances can be used.
∙ Please note and follow the cleaning product manu-
facturers' instructions (concentration, contact time).
∙ Do not use alkali, acidic or chlorine-based cleaning
products or cleaning products with scouring agent
additives.
∙ Do not use any scouring cleaning equipment, e.g.
brushes.
∙ Do not apply the cleaner directly to the surface,
but always pour it on the cleaning cloth instead.
Disclaimer
HEWI does not accept any liability whatsoever for
personal injuries or damage to property that is or
has been caused due to incorrect assembly, installa-
tion or use, especially due to disregard of the listed
warnings and safety instructions.
Disposal
Proper disposal is subject to the applicable national
statutory regulations.