Waeco PerfectView CAM30 Instrucciones De Montaje página 19

CAM30_CAM40.book Seite 19 Donnerstag, 14. Januar 2010 5:32 17
PerfectView
When the negative terminal of the battery is disconnected, all data stored in the volatile
memory will be lost.
The following data must be set again, depending on the vehicle equipment options:
– radio code
– vehicle clock
– timer
– on-board computer
– seat position
You can find instructions for making these settings in the appropriate operating
instructions.
Observe the following installation instructions:
Secure the parts of the camera installed in the vehicle in such a way that they cannot
become loose under any circumstances (sudden braking, accidents) and cause inju-
ries to the occupants of the vehicle.
Secure any parts of the system covered by the bodywork in such a manner that they
cannot be come loose or damage other parts and cables and impair vehicle functions
(steering, pedals, etc).
To prevent damage, when drilling ensure that there is sufficient space on the other
side for the drill head to come out (fig. 1, page 3).
Deburr all drill holes and treat them with a rust-protection agent.
Always follow the safety instructions of the vehicle manufacturer.
Some work (e.g. on retention systems such as the AIRBAG etc.) may only be per-
formed by qualified specialists.
Observe the following instructions when working with electrical parts:
Only use a diode test lamp or voltmeter to test voltages in electric cables.
Test lamps with an illuminant consume voltages which are too high and which can
damage the vehicle's electronic system.
When making electrical connections, ensure that
– they are not kinked or twisted
– they do not rub on edges
– they are not laid in sharp edged ducts without protection (fig. 2, page 3).
Insulate all connections.
Secure the cables against mechanical wear with cable binders or insulating tape,
for example to existing cables.
Safety and installation instructions
19