Using The Light - Perel EFL29 Manual Del Usuario

Insert a new 3 V CR2025 battery, with the + side facing up. If you
2.
install the battery correctly, the device starts playing a tune. Press any
control button [4] to stop the sound.
Place the battery cover back and turn it clockwise to close.
3.
Charging the Internal Battery
The internal rechargeable battery powers the LED light. Recharge the
battery when the LED light starts to fade. Proceed as follows:
•
Plug one end of the included USB cable into the light's USB port [7],
and plug the other end into a free USB port of your pc.
The red indicator LED [6] lights up while the battery is charging. When the
LED goes out, the battery is fully charged.
Wall Mounting
You can place the light freestanding on a table or desk, or you can hang it
on a wall using the included mounting plate. Proceed as follows:
Choose a safe mounting location where you cannot accidentally knock
1.
the light off the wall.
Fix the mounting plate [9] on the wall.
2.
Hook the notches in the light's base plate [8] over the protrusions on
3.
the mounting plate.
7. Operation

7.1 Using the Light

Make sure that the internal battery is charged.
1.
Fold open the light and briefly touch the light switch [3] to switch on
2.
the light.
To dim the light, touch and hold the light switch until you get the
3.
desired brightness.
To increase the brightness, touch and hold the light switch again.
4.
To switch off:
5.
Touch the light switch.
o
Fold up the light.
o
7.2 Temperature
The display shows the ambient temperature in °C or °F. To switch between
°C and °F, press the DOWN button [4].
7.3 Calendar
To set the date and time, proceed as follows:
Press the UP button [4] to switch between 12 or 24-hour display
1.
mode. Note: in 12-hour display mode, the PM indicator appears on the
display in the afternoon.
V. 02 – 28/04/2015
EFL29
6 ©Velleman nv