Operation; Operation Interface; Turning On The Warewasher; Warewasher Ready To Operate - Classeq D400 Manual De Usuario

6. Operation

Before operating the warewasher, ensure that the mains
electrical and water supplies are turned on.
Children must be supervised to ensure that they do not play with,
or operate, the warewasher.
6.1

Operation Interface

Item Description
1 On/Off button
2 Cycle button
3 Cycle indicator (Note 2)
4 Fill/Heat indicator (Note 1)
5 Program Select button
6 Temperature Units button
7 Program indicator
8 Wash Temperature display
9 Rinse Temperature display
10 Temperature Unit display
11 Wash indicator
12 Rinse indicator
13 Refill Salt Indicator
(Note 3)
Notes:
1. Fill/Heat indicator:
FLASHING AMBER - warewasher not
ready (Wash Tank not full / Rinse Tank
not full / Wash Tank still heating / Rinse
Tank still heating).
GREEN - warewasher is ready / in
standby (Wash Tank full / Rinse Tank
full).
Note that Tank full interlocks always
apply. Operating temperature interlocks
can be altered as required (►5.6).
GREEN plus Cycle indicator BLUE -
warewasher will start the selected wash
cycle.
16
Classeq Under Counter Range - User Manual
2. Cycle indicator:
GREEN plus BLUE Cycle indicator
shows the- warewasher is in a wash
cycle.
BLUE plus Fill/Heat indicator
FLASHING AMBER - a wash cycle has
been selected but not started.
FLASHING BLUE - warewasher is
draining down (pumped drain
warewashers only).
RED - indicates that warewasher is in
Commissioning Mode.
RED plus warewasher turned off - a
serious error condition has occurred.
3. Fitted to warewashers with a Water Softener only.
6.2

Turning on the Warewasher

To turn on the warewasher, ensure the door is closed and press
the On/Off button (1) on the Control Panel. The display will
illuminate and the warewasher will start to fill, as long as the
door is closed.
6.3

Warewasher Ready to Operate

The warewasher operates a pulse fill function, this means that it
will fill the Rinse Tank, heat this to a pre-set temperature then
transfer this water to the Wash Tank. During the fill stage the
Fill/Heat indicator (4) will flash amber.
Once the Wash Tank is filled the Fill/Heat indicator will illuminate
green to indicate the warewasher is ready to run a cycle.
The time required for the warewasher to fill and heat will vary
depending on the power rating of the warewasher, as stated on
the rating label (►2.3), and the incoming water temperature.
Below is a guide to these fill and heating times when the
incoming water is 16°C.