Setting Up / Operation - Stadler Form Eva Manual De Instrucciones

1. Dip the testing strips into the water for a second.
2. After around one minute the results can be seen on the test strip.
Some of the green fields change colour into pink. The water hardness is
shown by how many boxes turn pink. Example: If three are pink, then the
water hardness is >14 °dH.
Number of
pink boxes
0/1
2
3
4
With a water hardness above 21 °dH, we can no longer recommend the use of
an ultrasonic humidifier. We recommend that you use an evaporative humidi-
fier to increase the humidity in your house (e.g. an Oskar humidifier made by
Stadler Form: www.stadlerform.com/Oskar).
Note: Do not operate Eva with decalcified water out of a decalcification sys-
tem that uses the principle of an ion exchanger (salt is added to the water).
The salt contained in the water may lead to white dust accumulation around
the appliance. To minimize this risk, you can operate Eva using a mix of dis-
tilled and tap water.
However, Eva may be operated from a drinking water filter system (e.g. Brita).
Should you be unsure about the quality or composition of the water in your
area, contact the caretaker or your drinking water provider.

Setting up / operation

1. Put Eva in the desired location on a flat surface. The mist reaches a height
of up to 1.4 m thanks to the high-performance humidification (output level
5, warm mode on). This makes it possible to place Eva directly on the
floor. Connect the power cord (1) to a suitable socket.
2. Take the Remote Sensor
the packaging. Open the battery compartment (4) on the underside of the
Remote Sensor
teries into the battery compartment (4), as shown on page 4, and close
the lid again. Now place the Remote Sensor
3. On the one hand, the Remote Sensor
antees precise humidification by its external position. On the other hand,
the Remote Sensor
humidity sensor Remote Sensor
or a sideboard with an optimal distance from Eva between 3 – 5 m. The
Remote Sensor
room air can flow past the sensor (5) as freely as possible. If this is not
possible, we recommend positioning the Remote Sensor
mum distance of 30 cm from the wall and a minimum distance of 2 m from
windows and ventilation openings.
4. Remove the water tank (6) by holding it by the handle and pulling it up.
Water Degree of
hardness hardness
(°dH)
Soft
From 4 °dH
Moderately
From 7 °dH
hard
Hard
From 14 °dH
Very hard
From 21 °dH
(2), the stand (3) and the two batteries out of
TM
(2) by turning the lid anticlockwise. Insert the two bat-
TM
(2) also serves as a remote control. Position the
TM
should be positioned centrally in the room so that the
TM
Cartridge will last for
Days
90 days
45 days
30 days
15 days
(2) on the stand (3).
TM
(2) is a humidity sensor and guar-
TM
(2) in the centre of the room on a table
TM
(with 4 liter/day)
Liter
approx. 360 L
approx. 180 L
approx. 120 L
approx. 60 L
with a mini-
TM