Safety And Installation Instructions - Dometic MAGICSPEED MSBE 7 Instrucciones De Montaje

MagicSpeed MSBE7
2

Safety and installation instructions

The manufacturer accepts no liability for damage in the following cases:
• Damage to the product resulting from mechanical influences and excess voltage
• Alterations to the product without express permission from the manufacturer
• Use for purposes other than those described in the operating manual
Please observe the prescribed safety instructions and stipulations from the vehicle
manufacturer and service workshops.
!
WARNING!
Inadequate supply cable connections could result in short circuits, which could have as
a consequence that:
• Cable fires occur
• The airbag is triggered
• Electronic control devices are damaged
• Electric functions fail (indicators, brake light, horn, ignition, lights)
A
NOTICE!
To prevent the risk of short circuits, always disconnect the negative terminal of the
vehicle's electrical system before working on it.
If the vehicle has an additional battery, its negative terminal should also be discon-
nected.
If you disconnect the negative terminal of the battery, all data stored in the volatile memories will
be lost.
• The following data must be set again, depending on the vehicle equipment options:
– Radio code
– Vehicle clock
– Timer
– On-board computer
– Seat position
You can find instructions for making these settings in the appropriate operating instructions.
Observe the following installation instructions:
• Secure the parts installed in the vehicle in such a way that they cannot become loose under any
circumstances (sudden braking, accidents) and cause injuries to the occupants of the
vehicle.
• Secure any parts of the system covered by the bodywork in such a manner that they cannot be
come loose or damage other parts and cables or impair vehicle functions (steering, pedals,
etc).
• Always follow the safety instructions of the vehicle manufacturer.
Some work (e.g. on retention systems such as the AIRBAG etc.) may only be performed by
qualified specialists.
• To prevent damage when drilling, make sure there is sufficient space on the other side for the
drill head to come out.
EN
Safety and installation instructions
7