Installation - brondell FSW-20 Manual Del Propietário

Installation

Check the size of the hot water supply connection (most likely
under the sink/wash basin) . This needs to be a 3/8" connection
for our T-valve to install . Note: if the connection is a ½"
connection, you will need to purchase the following reducing
adapter available online and at many plumbing hardware stores:
Reducing Adapter, ½" Female NPT X 3/8" Male Compression.
Check Water Supply Line:
connects the toilet tank fill valve to the water shutoff valve at
the wall . If it is a rigid pipe, you will need to purchase a flexible
water supply hose to replace it before installing the FreshSpa .
The length of the hose may vary and the top connection size
should be 7/8" Ballcock to connect to the T-valve that you will
install under the toilet tank and the bottom connection will vary
(most common are 3/8" and1/2"female compression) .
1) Remove Existing Toilet Seat
a. Lift hinge covers and use flathead or Phillips head screwdriver
to remove the mounting bolts . Alternatively, you may need to
loosen mounting bolts underneath the seat .
b. Remove the toilet seat and set the seat, mounting bolts and
hardware aside .
Check the water supply line that
5