Setup And Operation; Using Accessory Tools; Machine Maintenance - Castex UV-1600 Manual Del Operador

OPERATION

SETUP AND OPERATION

FOR SAFETY: Do not operate machine, unless
operator manual is read and understood.
WARNING: Fire Or Explosion Hazard. Never
Use Flammable Liquids Or Operate Machine in Or
Near Flammable Liquids, Vapors Or Combustible
Dusts.
1. Connect only to a grounded 120 volt A.C. (3 hole)
electrical outlet (Figure 1).
Grounded
3 Hole Outlet
Ground Pin
FIG. 1
FOR SAFETY: Do not use machine unless cord is
properly grounded.
FOR SAFETY: Do not operate machine with the
use of extension cords.
2. Before beginning operation, always check to make
sure that there is a bag installed in the vacuum
housing.
ATTENTION: Operation without a bag or with a
full bag will damage your vacuum. Damage due to
these causes is NOT covered by warranty.
3. Close the vacuum housing lid and latch it.
4. Adjust the brush height by tilting the vacuum back
and turning the black knob on the base housing.
Select from 1 for shortest pile carpet to 6 for
longest pile carpet, or any setting in between.
5. Place your right foot on the toe kick to hold the
base, then pull the handle back to the vacuuming
position.
6. Turn on the power switch located on the handle.
WARNING: Fire Or Explosion Hazard. Do Not
Pick Up Flammable Or Toxic Materials, Burning Or
Smoking Debris.
7. Begin vacuuming. When cleaning under beds or
other hard to reach areas, you can lower the
handle to the floor for easy clearance.
6
Home Find... Go To..
8. Periodically check the vacuum bag level. For best
cleaning results, change the bag when it becomes
three--quarters full.
9. When you change the bag, also check the
condition of the secondary filter. If it is dusty,
remove and clean it. A clogged filter can reduce
airflow and cleaning power.
NOTE: If the brush stops during use, unplug the
vacuum and dislodge any obstructions near the
brush. Then, push in the brush reset button located at
the rear of the vacuum, near the wheels.
WARNING: Electrical Hazard. Unplug power
Cord Before Servicing Machine.

USING ACCESSORY TOOLS

1. You can use accessory tools with your vacuum.
To attach these tools, disconnect the hose from
the brush housing. Leave the other end of the
hose connected to the vacuum housing.
2. Connect the accessory tool to the hose.
3. With the handle locked in the upright position, turn
on the switch and begin vacuuming.
NOTE: The brush will not run while the handle is
locked in the upright position. An automatic switch
shuts the brush motor off in this position.
WARNING: Fire Or Explosion Hazard. Do Not
Pick Up Flammable Or Toxic Materials, Burning Or
Smoking Debris.

MACHINE MAINTENANCE

WARNING: Electrical Hazard. Unplug power
Cord Before Servicing Machine.
If the supply cord is damaged or broken, it must
be replaced by the manufacturer or it's service
agent or a similarly qualified person in order to
avoid a hazard.
1. The most important step is to remove carpet
strands and other clogging debris from the brush
after every use. This simple step can extend the
life of your brush bearings.
2. Check the vacuum bag level frequently to prevent
overfilling the bag. Always dispose of paper bags
when they become full, do not reuse them. If
using a cloth bag, empty the bag and shake out
excess dust. Also, inspect the cloth bag for
tearing or holes each time you empty it.
UV-1600 (07- -05)