Reassembly - Pentair Water GreatWhite Guía De Instalación Y Usuario

Reassembly

1. Put both white seals in the oscillator; hold them in place.
2. Install the oscillator on the long gear shaft. Install the
ratchet gear on the shaft so that the teeth engage the
ratchet on the oscillator. Install the spring, ratchet drum,
pinion gear (large gear first), and cam (gear end first) on
the shaft (See Figure 28). Hold the gears on the shaft while
installing them, and compress the clutch spring to allow
assembly to slip into place between the posts (See Figure
28).
3. Install the long gear shaft and end blocks in the cleaning
head with the large arm of the cam down (see Figure 29).
4. Reinstall the short gear shaft, set screw and two gears
(See Figure 30); the small pinion gears and the shaft set
screw go on the side toward the end of the cleaner – away
from the oscillator box. Make sure that the gears engage
the gears on the long gear shaft.
5. Install the oscillator chamber cap and clip it in place.
6. Install the rubber vacuum skirt on the cleaner with the
word 'OUTSIDE' showing. Start at the large pin on the
back of the cleaner head (see Figure 31) and work around
the cleaner. Make sure the skirt is flush against the stop
strips on the cleaner head (see Figure 32).
7. Turn the cleaner over. If you removed the bumper and
brush ring, replace them now.
8. Install the lower body assembly in the shroud. Fasten the
cleaning head in place with 4 screws (2 long, 2 short – see
Figure 33).
NOTE: Make sure that you do not dislodge the rubber vac
skirt while inserting the lower body assembly past the brush
ring.
This
Figure 32
#10-16x1-3/4" Screws
Center
Brush
Location
#10-16x1" Screws
Bottom View of Cleaner
Figure 33
Not
This
1892 0795
Lift Brush
Location
Center
Start here with
large button when
Brush
installing vacuum skirt.
Location
1891 0795
Figure 31
Seals
Figure 28
Make sure Oscillator
is partially inserted in
chamber while reinstalling
Shaft Assembly
Oscillator
Chamber
Figure 29
Figure 30
'Outside' will show
(facing out) when
O U
skirt is correctly installed.
T S
I D E
Great White Installation and User's Guide
17
1894 0795
Swing Cam
Arm up for
Clearance
1895 0795
1890 0795
Rubber
vacuum skirt
1893 0795