Puky PUKYMOTO Manual De Instrucciones página 7

Ocultar thumbs Ver también para PUKYMOTO:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 27
the identification plate in the cycle passport at
the end of this manual so that you have all the
information you need in the event of any ques-
tions or when ordering spare parts.
Maintenance and care
Examine the vehicle at regular intervals for any
wear, and to check that the screws are still
properly tightened. Self-tightening nuts are
hard to loosen and must be replaced after
complete disassembly!
In order to maintain the high, design-specified
safety levels, all worn or defective parts are to
be immediately replaced by original PUKY
spare parts. For safety reasons, the vehicle
should not be used until it has been fully re-
paired. Bent or deformed parts should not be
repaired but instead should be replaced.
Spare parts: Wheels, handlebar grips
The vehicle must not be cleaned with a
high-pressure cleaner. Clean the tricycle using
a mild soapy solution and carefully wipe dry
using a soft cloth. Keep the vehicle away from
corrosion-promoting materials (road salt, sea
water, fertiliser). The vehicle must not be
stored in damp conditions.
Unpacking and scope of delivery
Do not use any sharp objects when opening
the packaging and removing protective materi-
al. By doing so, you may damage the paint or
parts of the vehicle.
Remove all parts from the packaging.
Remove the protective material. Keep all
packaging material out of reach of children
– there is a risk of suffocation.
User Manual
Examine the package for completeness and
proper condition. If anything is missing,
please contact your dealer before you start
to assemble the vehicle.
Scope of delivery (Figure A):
1. Frame incl. seat
2. Fork incl. front wheel
3. Handlebar
4. Rear axle with wheels
Assembly
The assembly instructions can be found on the
last pages of this manual.
You require the following tools for assem-
bly (Figure B):
1. Allen key 5 mm
Small parts which are required during assem-
bly (e.g. screws and washers) must be kept
out of the reach of small children. There is a
danger of suffocation as a result of swallowing
the parts. Also keep all packaging material out
of reach of children.
The bike must be assembled with great cau-
tion and by an adult to avoid any potential sub-
sequent accidents or injuries. Please take a
sufficient amount of time to assemble the bike.
Several assembly steps require manual skill
and practice in handling tools (e.g. spanner).
Please contact your dealer or a workshop if
you have any questions.
In some cases, it is necessary to tighten
screws with a prescribed torque. This torque
value is stated in Newtons (e.g. 2 Nm). If the
7
GB
Tabla de contenido
loading

Productos relacionados para Puky PUKYMOTO

Tabla de contenido