Tabla de contenido
Idiomas disponibles
Idiomas disponibles
3. Cleaning
Clean the refrigerator thoroughly at intervals, as
necessary. Remove the shelves; these, the cabinet
interior and the door should be washed with a warm
solution of sodium bi-carbonate. Finally wipe over with a
cloth rinsed in warm water only, and dry with a clean cloth.
Do not wash any plastic parts in water that is more than
hand warm, and do not expose them to dry heat. The
outside of the cabinet should be wiped down regularly with
a clean, damp cloth.
NEVER USE STRONG CHEMICALS OR ABRASIVE
CLEANING MATERIALS ON ANY PART OF THE CABINET.
4. Positioning the appliance
When first using this refrigerator please consider the
following points:
ENSURE REFRIGERATOR IS LEVEL
THE PIPEWORK AT THE BACK GETS HOT IN USE
THE REFRIGERATOR HAS NO 'MOTOR' AND IS
THEREFORE VIRTUALLY SILENT
ALLOW AT LEAST 3 HRS. FOR SIGNS OF COOLING
During the refrigeration process, the appliance gives
off heat from the condenser (under the upper part of
the rear cover) into the surrounding air. The more ventilated
the condenser is, the more effective the refrigeration will be.
The other condition for satisfactory operation is that the
appliance stands on a flat surface. This is best seen by
placing a glass of water on top of the appliance.
It is important that the appliance is not directly exposed
to radiated heat (sunlight, radiator, near an oven, etc.).
4.1. Installation instructions
The refrigerator is equipped with an electrically heated
absorption cooling unit which is virtually silent in operation.
The fridge is designed for free-standing installation, but can be
built-in if the following conditions are complied with to ensure
satisfactory operation and maximum cooling efficiency.
IMPORTANT
Please follow the installation details below carefully
Guarantee is valid for products installed as described
only.
1. The refrigerator must be level both directions
Figure 2.
2. There should be 20 mm clearance to the wall
3. Ventilation must be provided as shown in
alternatives A, B, C or D (fig 2-3)
Figure 3.
4. The ventilation duct must at least measure 105
mm x the width of the refrigerator
5. Only the entire cooling unit must project into the
duct as shown
6. Air passing through the duct must not be
preheated by any source of heat
7. Ventilation grills, if used, must have an free
openings of at least 200 cm
During installation, please ensure the mains plug is
accessible at all times.
5. Using the appliance
To start the refrigerator connect the plug to the socket
outlet and switch on the socket. The cooling fins should
show signs of cooling after about 3 hours.
The refrigerator needs about 6 hours at normal ambient
temperature to reach 6 °C in the storage compartment.
5.1. Temperature regulation
The usual setting required is in middle of the setting
range on the thermostat knob (Fig. 4-5), but this can
vary with conditions of load and installation. If it is found
necessary to alter the setting,the knob can be turned to
a higher number to produce a colder temperature, or a
lower number to produce a warmer temperature. The
effect of any adjustment can be checked by means of a
thermometer after leaving the refrigerator operating for a
further period to settle down again.
Figure 4.
GB
2
each
Figure 5.
5
Capítulos
Tabla de contenido
