Jet Operation And Adjustment; Repair Procedures - PROFLO PFS5838 Manual De Instalación Y Funcionamiento

JET OPERATION AND ADJUSTMENT

Pf6036 Jets: The jets can be easily adjusted by pointing the jet-nozzle in the desired direction. The strength of the
water flow and air induction can be regulated through twisting the jet- nozzle. Twisting the nozzle counter-clockwise
will decrease the water flow of that particular jet. If the nozzle is twisted clockwise then the water flow will increase up
to its maximum flow. Only a 1/4 turn or 90° turn is required from the lowest flow position to the fully OPEN position.
All other PROfLO jets: The jets can be easily adjusted by pointing the jet-nozzle in the desired direction. The
strength of the water flow and air induction can be regulated through twisting the jet- nozzle. Twisting the nozzle
clockwise will decrease the water flow of that particular jet If the nozzle is twisted counter-clockwise then the water
flow will increase up to its maximum flow. Only a 1/4 turn or 90° turn is required from the lowest flow position to the
fully OPEN position.
ON-Off SwITch fOR whIRLPOOL bAThS
The whirlpool bath pump is activated by an on-off switch. Each depression of the switch will actuate the pump. If off,
one depression will turn the pump on. If on, the next depression will turn it off.
ThIS PRODUcT IS DESIGNED fOR RESIDENTIAL USE
AND USE bY hEALThY INDIVIDUALS
Children should not be allowed to use these products without adult supervision. Pregnant women and those with heart conditions or other
conditions that limit normal physical activity should consult a doctor before use.

REPAIR PROcEDURES

Most minor scratches (up to 1/64" deep) and cigarette burns can be removed by sanding the area with #180 or #240 wet or dry sand
paper and progressing down to #600 or #1200 grit. Finally, apply light buffing compound and buff area with a clean stitched cotton buffing
pad or equivalent. Use an extra application of fine buffing compound if necessary. For Cracks and Major surface damage, call our service
line (800) 426-8964.
whIRLPOOL TROUbLE ShOOTING
MOTOR wILL NOT START:
1. Check Circuit Breakers.
2. Check for incorrect or loose wire connections.
3. Make sure the correct power supply is being used.
4. On/Off switch should be in the "On" mode. If you push the On/Off switch and you have no resistance when pushing it, the air tube may
be disconnected. Check if the air tube is properly connected at the motor and to the nipple of the ON/Off switch. If you hear a click sound
when you push the switch, but the motor doesn't begin to run, the electrical circuit of the motor may be defective.
5. Make sure that the jets are fully opened and water is flowing.
MOTOR OVERhEATING AND cYcLING ON AND Off:
1. Check for incorrect or loose wire connections.
2. Check for low voltage supply (frequently caused by undersized wire).
3. Make sure the motor gets a fresh air supply and the vents are kept unclogged.
MOTOR MAkES hUMMING NOISE bUT wON'T START:
1. Open jets see "illustration H"
2. Make sure that the motor shaft turns free.
3. Check for jammed impeller or an obstruction on the (volute) casing.
4. Check for low voltage and undersized wire.
LOw wATER fLOw:
1. Check for clogged plumbing lines.
2. Check for low voltage.
wATER LEAkS:
1. Check compression fittings (union connectors) making sure they are properly aligned and secured. HAND TIGHTEN ONLY. DO NOT
USE ANY TOOLS.
2. Make sure the O-ring is properly seated and not damaged.
SAVE ThESE INSTRUcTIONS
12 PROFLO.COM