Intended Use; Before First Time Use - OK. OPJ 103 Manual De Instrucciones

INtENDED USE

This appliance is only intended for preparing juices. This appliance is only suitable for private household
use and it is not designed for commercial purpose. Every other type of use can lead to damage to the
appliance or injury.

BEFORE FIRSt tIME USE

• Remove all packaging materials.
• Check for completeness and transport damage. In case of damages or incomplete delivery please
contact your dealer.
• Clean the appliance (
• Note: Due to the manufacturing process, the appliance may emit a slight burning odour when
switched on for the first time. This is normal and does not indicate any defect or hazard.
COMPONENtS
Fold out front and rear page for product illustrations.
1. Pusher
2. Lid with feeding chute
3. Locking groove
4. Stainless steel sieve with blade
5. Receptacle with lip
6. Spout
7. Base with motor
aSSEMBLy
WaRNING! Never connect the power plug into an electrical outlet before the appliance is fully
assembled.
Place the base on a dry, flat, and steady surface. Press the base firmly on the surface so that the
1
suction feet get a good grip.
Place the receptacle on the base. Make sure the spout and lip rest in place.
2
Attaching the pulp container: Insert its upper part under the receptacle lip. Push the lower part
3
firmly into the pulp container holder.
Insert the stainless steel sieve inside the receptacle, matching its bottom with the base shaft.
4
Lock the sieve in place: Press the sieve edge downward until a click is heard.
5
Place the lid on the juicer.
6
Lock the bar: Lift up the locking bar until it fits the locking grooves on both sides of the lid.
7
Insert the pusher into the feeding chute. Make sure the notch of the pusher fits the ridge on the
8
feeding chute top.
Place the juice container underneath the spout.
9
Now the appliance is assembled and ready for use.
IM_OPJ103_140515_V05.indb 15
15
Cleaning and care).
8. Juice container
9. Locking bar
10. Power cord with power plug
11. Anti-slip rubber feet
12. On/off switch (O, I, II, P)
13. Pulp container holder
14. Pulp container
EN
5/15/14 10:24 AM