Parts; To Set Up; To Use - Beurer TL 100 Manual De Instrucciones

2. Parts

1. Fluorescent screen
2. Timer Adjustment Buttons
3. Timer LEDs
4. Bluetooth LED
5. Brightness Adjustment Buttons
6. On/Off Button
7. AC Adapter Socket

3. To Set Up

Remove plastic wrapping and check the device for damage. If you notice any damage, contact customer
service.
1. Place the device on a flat, level, stable, hard surface so that it will be 8 – 24 inches (20 – 60 cm) away
from you during use.
2. To prevent product damage, only use the supplied AC Power Adapter.
3. Insert the round power adapter plug into the AC Adapter Socket on the rear of the Daylight Lamp Stand.
Connect the AC Power Adapter to a standard 110 VAC electrical outlet.

4. To Use

1. Press the On/Off Button. If you do not press any Timer Buttons, the light will stay on until you press the
On/Off Button again. To use the Timer, see step 3.
2. Sit 8 – 24 inches (20 – 60 cm) from the lamp. You can go about your normal activities during use, such
as reading, writing, using your phone, etc.
3. To use the Timer, press the +/- Timer Adjustment Buttons until the desired Timer LED illuminates on the
front panel. Usage time can be set to 15, 30, 45, 90, or 120 minutes. To deactivate the timer function,
press the "–" Button repeatedly until all LEDs shut off.
4. Usage duration depends on the distance; the closer you are to the light, the less time you should use it.
Distance
8 inches (20 cm)
8 – 16 inches (20 – 40 cm)
16 – 24 inches (40 – 60 cm)
5. To set the brightness level, press the +/- Buttons on the top of the lamp to increase or decrease the
brightness level. This lamp has 10 levels of brightness.
6. To activate the color-changing feature, when device is off, press and hold the On/Off Button for two
seconds. Press the On/Off Button again while this feature is activated to keep it on indefinitely and keep
it at current color. Press the On/Off Button again to deactivate.
7. Periodically look directly into the light very briefly. Do not stare directly at the light, however, since that
could overstimulate the retina.
8. For more effective results use for at least seven consecutive days between 6 AM and 8 PM for two
hours per day.
9. Start with shorter periods of usage and increase over the course of a week.
OTE: Eye aches and mild headaches may occur for the first few uses and will subside after continued use.
10. Press the On/Off Button to shut the unit off. Unplug the AC Power Adapter from the electrical outlet.
CAUTION
The light remains hot after use. Let the lamp cool before storing.
Duration
½ hour per day
1 hour per day
2 hours per day
4