Lavor HP Instrucciones De Montaje página 12

Connect the steam cleaner
Caution!
• Connect the machine only if the mains voltage corresponds to the rated
voltage reported on the rating plate.
• The main switch (4) and the heating switch (5) must be disconnected.
• The power cord (7) must not be damaged.
• The water tank must be filled with a sufficient water quantity (min. 0.5 l)
• The hose must be connected to the relevant accessory.
• The steam nozzle must not be obstructed.
Push the main switch (4); an orange light will appear (4/B).
Push the heating switch (5); a green light will appear (5/B).
The machine is in operation.
Water is heated and steam is generated.
When the green lamp lights up (3) the machine is ready to work.
Pour water into the boiler
Caution!
• When the machine is working, don't open the boiler cap (2)!
• The boiler cap may be supplied with an optional security. This security prevents the cap
unscrewing in case the boiler still contains steam
Warning
• When the boiler water is finished, the orange water indicator lamp will light up (6).
Filling
Disconnect the heating switch (5).
Keep the steam nozzle in the wash-basin.
Push the steam button (15) on the handle and keep it pressed until all steam has come
out.
Disconnect the main switch (4).
Move the electrical plug (7) from the supply socket.
Let the steam cleaner cool down.
Press the boiler cap (2) downwards and turn it anticlockwise at the same time, so as
to unscrew it completely.
Pour water into the boiler.
Put the cap on the boiler: press it downwards and turn it clockwise at the same time,
so as to screw it tight.
Disconnect the steam cleaner
Disconnect the heating switch (5) and the main switch (4).
Turn the steam intensity regulator (9) on position 0.
Pull out the electrical plug (7) from the supply socket.
Let the steam cleaner cool down.
Fit or remove accessories
Caution!
• Never work with wet hands
• The steam cleaner must be disconnected
• Accessories get hot when the machine is working. Be careful when replacing
the accessory during operation.
Fit the extension pipe
Push the spring button (18) on the steam nozzle handle (16)
Fit the steam nozzle handle (16) into the sleeve of the extension pipe (17) until the
spring button (18) snaps.
Fit the brushes
• In order to be able to use the rectangular or the triangular scrubbing
brush, it is necessary to connect the brush-joint (23) first:
Keep the brush-joint downwards pointed and insert
it completely into the brush. Turn then the brush-
joint upwards pointed.
Push the spring button (18) on the steam nozzle
handle (16) or on the extension pipe (17).
Fit the brush-joint (23) into the steam nozzle handle
(16) or into the extension pipe (17), until the spring
button (18) snaps.
Push the spring button (18) on the steam nozzle
handle (16) or on the extension pipe (17).
Remove the extension pipe (17) or the brush-joint
(23) from the steam nozzle handle (16).
Keep the brush-joint downwards pointed and
remove the brush from the brush-joint
Connect or remove the steam hose
is provided with it).
(only if the steam cleaner)
Caution!
• The steam hose and the power cord must be in very
good conditions.
• The steam cleaner must be unplugged.
• Work only with dry hands
Connect the steam hose
Lift the safety cap (21).
Snap the quick coupler plug (12) till the safety pin
(14)(upwards pointed) fits in the corresponding
cap hole (21).
Release the safety cap (21).
19 20
(optional)
(optional)
14 21
12
22