Back Panel External Connections - Standard Accessories; Pc-Interface - Interacoustics AC40 Manual De Instrucciones

AC40 Instructions for Use - EN
3.1 Back Panel External Connections – Standard Accessories
The back panel contains all the rest of the main connectors (sockets):
LAN (for
future use)
USB connectors
Power
for printer, PC-
connector
connection &
keyboard
Special notes:
•
The HLS (hearing loss simulator) connector is currently not used. Use the Standard Headphone
and HF Headphone connectors for HLS. This is prepared for future use.
•
In addition to the standard DD45 headset, four other air conduction transducers may be used
(they all connect to specific outputs on the AC40):
•
HDA300: High Frequency requires a HF headset.
•
CIR33 for insert masking: Insert phone CIR33 for insert masking has a limited sound
quality, making it only adequate for masking noise presentation.
•
EAR-Tone 3A or 5A general purpose insert phone: Insert headphone EAR-Tone 3A or
5A are high quality transducers that may be used instead of the DD45/TDH39. It
improves cross hearing from the normal approximately 40dB of the TDH39 to
approximately 70dB. Masking as well as avoiding over-masking is thus easier with this
type of headphone.
•
IP30 insert phone is the standard insert phone with same properties as EAR-Tone 3A
•
Currently FF3/FF4 (both the powered and non-powered) is not used. This is prepared for future
use.
•
Assistant Monitor: There is always a direct connection through the goose neck microphone to the
assistant wearing a headset connected to the "Assistant Monitor" output.
•
The LAN connection is currently not used for any application (only internally in production).
•
Mic 2: Please refer to the section about Patient Communication (Talk Forward and Talk Back).
•
When using the HDMI output the output resolution will be the saved as on the build in 8,4 inch
display: 800x600.
•
CD-input: It is required that any attached CD-player has a linear frequency response in order to
comply with the requirements of IEC 60645-2.
•
USB connections is used for:
•
PC connection to Diagnostic Suite (the large USB connector)
•
Direct print
•
PC-keyboard (for entering client names)

3.2 PC-Interface

Please refer to the Diagnostic Suite operation manual regarding hybrid mode (on-line and PC-operated
mode) as well as patient/session data transfer.
Amplified
Free Field
High Freq.
outputs
Left / Right
(2x20
HDMI output
Free Field 1
for external
and 2
monitor (e.g.
(external
for patient
amplificatio
counceling)
n needed)
Response
Switch 1 / 2
Insert
Bone conductor
masking
B81 /B81
1 / 2
Standard
Standard
Headphone
Insert Phone
s
EarTone 3A
DD45/TDH3
/ IP30
9/HDA300
Page
Patient
Assistant
Monitor
Control
output
Extra Talk
For Talk
forward
Back
mic., e.g.
Speaker
for table
mic.
6
External
CD / MP3
input