GBC DocuSeal XLP Laminator Instrucciones De Servicio página 4

DocuSeal XLP Laminator
Operation, hot lamination
Connect power cord to appropriate power source.
Push power button to "ON" position. The green power indicator will
1
illuminate.
2 Using the included lamination guide, select appropriate temperature setting
for the pouch gauge thickness and material you are laminating.
Temperature Setting Guidelines*
When laminating thin paper with light ink coverage, set the temperature
dial at the low end of the range. Thick paper and heavy ink coverage
require higher settings within the range. Temperature setting will vary due
to the finish, chemistry and heat absorption properties of the material
being laminated. If pouch is cloudy the first pass through the machine,
adjust temperature higher and run through again. If waviness occurs,
reduce the temperature. Always allow sufficient time for laminator to
adjust to changes in temperature setting.
Operation, cold lamination
Connect power cord to appropriate power source.
Push power button to "ON" position. The green power indicator will
1
illuminate.
Turn temperature knob to the cold setting.
2
3 Follow the instructions include with your GBC Self Adhesive laminate
or other pressure-sensitive, non-thermal laminating pouches.
Anti-jam feature
To correct misfeeds press and hold the "Release" button, located at the back of
the machine (fig. 2), while pulling the misfed material out of the laminator.
Specifications
Electrical
Machine Dimensions
Machine Weight
Maximum Pouch Width
Maximum Pouch Thickness
Warm-Up Time
GBC Docuseal XLP
230V/50Hz/3.1A/700W
500 x 190 x 114mm
3.9kg
324mm
250 mic.
3-5 min./75 mic.
3 The inside of the laminator will glow red when the laminator has reached
operating temperature.
4 Position the item to be laminated into a GBC laminating pouch,
so that the document is aligned to the folded edge and right and left
borders are equal.
Insert the pouch and its contents straight into the machine, leading with
5
the sealed edge (fig. 1).
6 The laminated document will automatically exit the rear of the laminator.
After the pouch has stopped moving, place it on a flat surface to cool
before handling.
When you are finished laminating, push the power switch to "OFF".
7
Do not laminate an empty pouch.