Back Angle Adjustment; Back Height Adjustment; Back Rest Adjustment - Zippie Pluton Manual De Usuario

Sistema de assento
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

13.0 Back Rest Adjustment

Refer to Fig.13.1-13.2

Back Angle Adjustment

At the lower back of the chair squeeze together levers
(A), this releases them from their holding position in
holes (B).
Whilst holding the levers together, hold the chair by the
top of the back and guide the angle of the back into the
required position.
Relocate the levers into the relevant positioning holes
(B) to secure the back in place.
Always ensure that the back is secure and that the
levers are located fully in a hole before using the chair.

Back Height Adjustment

Remove the back pad cushion which is held in place
by press studs.
Loosen the two allen key bolts (A) on the plastic back
panel.
Slide the plastic panel up or down to the desired
height.
Tighten the two allen key bolts securely.
Replace the back cushion pad.
Pluton Rev.1.0
Fig.13.1
B
Fig.13.2
A
A
19
Tabla de contenido
loading

Tabla de contenido