Epson TM-L90 Manual Del Usuario página 12

English
1. Insert the roll paper spacer so that the front edge goes through the
notch and down to the shaft, as shown below.
front edge
2. Push the roll paper spacer until you feel it click onto the shaft.
Note:
Check that the roll paper spacer slides smoothly to the left and right.
shaft
3. Slide the roll paper spacer to the appropriate width, as shown
above. You can use the measurement printed inside the printer,
aligning the inside edge of the spacer with the desired
measurement.
Width note:
When you want to set the roll
paper width from 61 mm to
70 mm, break off by hand the
two tabs of the spacer shown in
the illustration. (You can still
also use widths from 38 mm to
60 mm with the spacer with the
tabs broken off.)
8 TM-L90 User's Manual
notch
roll paper
spacer
inside edge of
the spacer
tabs