Coffee Dose Programming - LAVAZZA A Modo Mio DESEA Instrucciones De Uso

EN IT

COFFEE DOSE PROGRAMMING

Measures are always programmed using the same but-
ton; any action by pressing other buttons will be ignored.
The programmed amount of brewed coffee can be
changed by repeating the programming.
It is not possible to program the coffee dose in milk-
based beverages.
Press the On/Stand-by button
chine on. The machine will be ready when the On/
Stand-by button stops blinking and the supply but-
ton lights are steadily.
Lift the pod loading lever until it locks into position to
open the pod fitting compartment.
Put a Lavazza
fitting compartment.
Lower the pod loading lever to close the pod fitting
compartment. Place the cup onto the plate.
PROGRAMMING
to switch the ma-
capsule into the capsule
Press down the button of the icon you wish to pro-
gram. The machine will start supplying and, after ap-
proximately 3 seconds, the other coffee buttons will
start blinking and the machine will beep, to indicate
that the programming mode has been accessed.
Keep the supply button depressed
Once the desired amount of coffee has been obtained,
stop supply by releasing the button.
The machine will stop and the dose will be pro-
grammed
If the programmed measure exceeds the maximum al-
lowed the machine will automatically stop delivery, the
delivery button will blink and the last programmed meas-
ure will be saved in the memory.
If there is a power failure during programming, the last
programmed value remains in the memory.
If during a dose programming, water lack is indicated,
the machine stops the supply and the dose being pro-
grammed won't be saved. Once filled the water tank,
repeat the dose programming procedure.
58