Operating Elements And Connections; Safety Notes - Monacor CARPOWER HPB-418/SW Manual De Instrucciones

Please unfold page 3. Then you can al-
ways see the operating elements and
connections described.
1 Operating Elements and
Connections
1 Line inputs for the rear channels
2 Control for level matching of the rear
channels
3 Power LED
4 Bass and treble controls for the rear
channels
5 Control for level matching of the front
channels
6 Line inputs for the front channels
7 Ground terminal
8 +12 V supply voltage
9 Control input +12 V to switch on the
power amplifier
10 Fuse 15 A;
only replace a blown fuse by one of the
same type
11 Connections of the rear speakers:
green + left speaker
blue - left speaker
grey - right speaker
yellow + right speaker
12 Connections of the front speakers:
green + left speaker
blue - left speaker
grey - right speaker
yellow + right speaker

2 Safety Notes

The unit corresponds to the directive 89/336/
EEC for electromagnetic compatibility.
While connecting the car HiFi power
amplifier to the car battery, be especially
careful. In case of short-circuits there may
be dangerously high currents. Therefore
prior to the connection screw off the nega-
tive terminal of the car battery.
The power amplifier must be mounted at a
mechanically rugged place in the car in a
fixed and skilful manner, so that it does not
become loose and a dangerous projectile.
For cleaning only use a dry, soft cloth, by
no means chemicals or water.
If the power amplifier is used for purposes
other than originally intended, if it is oper-
ated, connected, or repaired in the wrong
way, no liability can be taken over for pos-
sible damage.
If the unit is to be put out of operation defi-
nitively, take it to a local recycling plant for
disposal which is not harmful to the envi-
ronment.
3 Mounting
While choosing the mounting place, watch
the following items:
The power supply cables from the battery
to the power amplifier should be as short
as possible. It is better to use longer
speaker cables and shorter power supply
cables.
As the power amplifier becomes very hot
while in operation, a sufficient ventilation
must be provided.
As forces may occur while braking, the
power amplifier must be screwed at a
mechanically rugged place.
The fuse and controls must be accessible.
For mounting use the four drill holes in the
heat sink. Firmly mount the power amplifier
at a suitable place with 4 screws.
4 Caution in Case of
High Volumes
Never adjust the volume very high. Ex-
tremely high volumes may damage the
hearing.
A person's hearing gets accustomed to
high volumes which after some time do
not seem to be so high. Therefore do not
increase a high volume even further after
getting used to it.
While driving in a car, the volume of the
car HiFi system must not be adjusted so
high that the signal sirens e. g. of an
ambulance car cannot be heard any
more.
GB
7