Filling The Fuel Tank - Garland XTRIM 900 G Manual De Instrucciones

English
Store fuel in a bottle or tank homologated and
according to current regulations.
If you will mix more combustible just prepare the
amount you will use the short term. Do not use
fuel that has been stored over two months. The
fuel stored for long periods lose its characteristics
making it harder to start the engine and giving poorer
performance.

6.3.2. FILLING THE FUEL TANK

1. Choose an open area to perform this situation
2. Stay away from the area where you have made the
preparation of the mixture.
3. Remove the combustible tank cap and fill with
fuel mixture without completing the full.
4. Close tighly the fuel cap and remove all traces of
fuel that have been spilled with a rag.
WARNING: Always switch off the engine before
refueling.
Do not perform this operation in an enclosed
or poorly ventilated.
Stay away at least 3 meters from the zone where you
have refueled before started the machine.
6.4. START UP
6.4.1. START UP IN COLD
1. Move the air lever (e) to the cold start position.
2. Place the switch (a) in the position ¨I¨ (start).
3. Press the primer bulb several times (f) (7 to 10
times) until the fuel reaches the carburetor.
4. Press the security button (b) and after that press
the accelerator trigger (c).
5. Pull the starter rope until you hear the engine start.
6. Move the air lever (e) to the normal
working position.
7. If the engine exploded but did not actally start
running, pull the start rope again until it starts.
Allow the engine to warm up for approximately one
minute before starting to work with the machine.
6.4.1. STARTING THE MACHINE FROM HOT
1. Move the switch (A) to the START position.
2. Move the lever (E) to the
3. Pull the start rope until the machine starts.
If the machine does not start after pulling at the rope a
few times, please refer to the cold start up section.
6.4.2. ENGINE STOPPAGE
1. Let go of the accelerator (C) and let the engine run
at idle speed for a few seconds.
. 2. Stop the engine by displacing the switch from the
(A) position to the ¨O¨ position (stoppage).
6.5. POINTS TO BE VERIFIED AFTER MACHINE
STARTS
It is neccesary to pay attention to posible loosening
or overheating of parts of the machine. If you detect
32/104
position.